LF PORTFOLIO OUTDOOR EL9070BK-4 Manual Del Usuario página 5

For each fixture, unscrew the top cover of the
4.
fixture connector (D) counterclockwise from
the bottom base and remove the press plate
and contact plate.
Insert and press the wire from the fixture into
5.
the contact plate, then insert low-voltage cable (G)
from the power pack (F) into the bottom base of
fixture connector (D).
Note: Make sure the fixture wire from the light is
placed flat and aligned with rib on the bottom
base during tightening.
6. Using the locking tabs on the contact plate of
the fixture connector (D), make sure the top
cover is snapped securely into place; it should
turn freely.
4
Top Cover
D
5
6
5
Press Plate
Contact Plate
Bottom Base
Contact Plate
D
Bottom Base
G
Wire
Top Cover
Contact Plate
D