Care And Maintenance - LF PORTFOLIO OUTDOOR EL9070BK-4 Manual Del Usuario

CARE AND MAINTENANCE

• Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker
off or removing the fuse from the fuse box.
• To clean the fixture, use a dry or slightly dampened clean cloth.
• DO NOT use any cleaners with chemicals, slovents, or harsh abrasives as damage to the fixture
may occur.
• DO NOT touch new bulb with bare hands as oil from skin may damage the lamp and cause short
bulb life.
• Bulb Replacement: Use 20-watt, 12-volt MR16 bulb.
TROUBLE SHOOTING
PROBLEM
1. The wire of the connector
The light does
not turn on
when needed.
2. The wire and the
3. No power to the transformer. 3. Check the power to the transformer.
4. Power pack overloaded.
WARRANTY
The manufacturer warrants this lighting fixture against defects in materials and workmanship for a
period of one year from the date of purchase. If within this period the product is found to be
defective in material or workmanship, the procudt must be returned, with a copy of the bill of sale as
proof of purchase, to the original palce of purchase. The manufacturer will, at its option, repair,
replace or refund the purchase price to the original purchaser consumer. This warranty does not
cover light bulbs or the fixture becoming damaged due to misuse, accidental damage, improper
handling and/or installation and specifically excludes liability for direct, incidental or consequential
damages. As some states do not allow exclusions or limitations on an implied warranty, the above
exclusions and limitations may not apply. This warranty gives you specific rights and you may also
have other rights that vary from state to state.
REPLACEMENT PARTS
For replacement parts, call our customer service department at 1-800-643-0067, 8 a.m. - 6 p.m.,
EST, Monday - Thursday, 8 a.m. - 5 p.m., EST, Friday.
PART DESCRIPTION
E
POSSIBLE CAUSE
doesn't contact pins.
transformer aren't in contact.
PART#
Stake 0099392-E
CORRECTIVE ACTION
1. Check the wiring of connector. Make sure brass
contact pins pierce the plastic wire insulation and
are touching the copper wires inside.
2. Check the connection between the primary wire
and the transformer.
4. Check wattage of all fixtures.
E
7
Printed in China