Buffalo HD-QLU3R5 Manual De Usuario página 22

6
When "Check again that there is no important data on the target drive. Are you
sure you want to proceed?" is displayed, click [Yes].
Building of the RAID array is started.
When the message "RAID Management drive is registered. Please connect HD-xLU3
again." is displayed, disconnect the DriveStation from the computer, then reconnect it.
7
When the message "The setting was successfully changed." or "The operation
mode was changed." is displayed, click [OK].
Building of the RAID array is now complete.
Notes: For users of Windows Server 2003
After building the RAID array, the DriveStation must be initialized using the NTFS format. Format
the DriveStation while referring to the on-screen manual "Formatting Guide".
For Macintosh users
After building the RAID array, the DriveStation must be initialized using the MacOS Extended
format. Initialize the DriveStation while referring to the on-screen manual "Formatting Guide".
If the DriveStation is connected to a computer after building the RAID array, the access lamp
may glow green and the DriveStation may not be recognized properly. In this case, turn off the
power for the DriveStation, then turn it on again.
HD-QLU3 User Manual
21