Hollywog WiTouch Manual De Usuario página 4

OPERATE your Hollywog WiTouch
1. Remove the green protective liners from both gel pads on the device by slowly peeling the liner from one inside corner towards
the outside corner of the electrode area. DO NOT discard the protective liners as the protective liners will be reapplied to the
gel pads for storage after use. Take care to not touch or allow objects to come in contact with the gel pad as this may interfere
with the adhesion properties of the gel pad.
2. Place the device on your back over the area of back pain, aligning the center of the device over the spine. Make sure the gel
pads make good contact with the skin. DO NOT apply the gel pads/electrodes directly over the spine. If the area of back pain
cannot be accessed, request assistance from another person for application.
3. On the Hollywog WiTouch remote control, press the START/STOP TREATMENT button momentarily. The LED will blink
green one (1) time. The Hollywog WiTouch electrical stimulation treatment has now started. On the WiTouch device,
the LED will now begin blinking green very rapidly for the duration of the treatment.
4. Press the INCREASE INTENSITY (+) button to increase the stimulation to a comfortable level. To decrease the stimulation
intensity anytime during treatment, press the DECREASE INTENTISY (-) button.
5. Treatment will automatically stop after 30 minutes. Treatment can be stopped at any time by pressing the START/STOP
TREATMENT button on the remote control. DO NOT remove the device until treatment has stopped.
6. Care should be taken to not inadvertently depress the ON/OFF button on the device when being worn. If the ON/OFF button is
depressed during use, the treatment will stop. To restart treatment, press and hold the ON/OFF button for 1 second, then
initiate the treatment with the remote control. The 30 minute treatment will start over from the beginning.
7. The Hollywog WiTouch device can be left in position without removal for multiple treatments during the day. To initiate
additional treatments, repeat step 3 above when treatment is desired. NOTE: It is recommended to wait a minimum of 30
minutes between treatments.
8. The Hollywog WiTouch device will automatically turn off after two (2) hours of inactivity. To turn on the device, press
and hold the ON/OFF button on the WiTouch device for one (1) second. The LED will begin blinking green once every two (2
seconds). On the Hollywog WiTouch remote control, press the START/STOP TREATMENT button momentarily. The LED will
blink green one (1) time. The Hollywog WiTouch electrical stimulation treatment has now started. On the WiTouch
device, the LED will now begin blinking green very rapidly for the duration of the treatment..
STORE your Hollywog WiTouch
1. When you have completed treatments and ready to store the Hollywog WiTouch, you can remove the device from your
back. Slowly peel the WiTouch device away from the skin, grasping the edge of the device and gel pad simultaneously to
ensure gel pad does not come off the device and stay on the skin.
2. Apply the green protective liners to the gel pads. Make sure the gel pad is completely covered.
3. Press and hold the ON/OFF button on the device for 1 second to turn off the device. The LED will will stop blinking green.
4. Place the Hollywog WiTouch device and remote control in the storage box.
5. If the Hollywog WiTouch is not to be used for a long period of time, remove the 2 AAA batteries from the Hollywog
WiTouch battery compartment to prolong battery life.
6. To turn on the device, press and hold the ON/OFF button on the WiTouch device for one (1) second. The LED will begin
blinking green once every two (2 seconds). On the Hollywog WiTouch remote control, press the START/STOP
TREATMENT button momentarily. The LED will blink green one (1) time. The Hollywog WiTouch electrical stimulation
treatment has now started. On the WiTouch device, the LED will now begin blinking green very rapidly for the duration of
the treatment.
REPLACE Hollywog WiTouch Gel Pads
Hollywog WiTouch Gel Pads are single person use. The gel pads will last for approximately 2-5 applications. The number of
applications will vary person-to-person depending upon skin type, oils and PH levels. When the gel pads no longer adhere completely,
it is time to replace the gel pads. To purchase replacement gel pads for your WiTouch device contact your original purchase retailer.