Handle Assembly - Hoover F3860/1-011 Manual Del Usuario

GB
The Environment:
This appliance is marked according to the European directive 2011/65/EC on Waste Electrical and Electronic
Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could otherwise be caused by inappropriate
waste handling of this product. The symbol on the product indicates that this product may not be treated
as household waste. Instead it shall be handed over to the applicable collection point for the recycling of
electrical and electronic equipment. Disposal must be carried out in accordance with local environmental
regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this
product, please contact your local city office, your household waste disposal service or the shop where you purchased
the product.
This product complies with the European Directives 2014/35/EU, 2014/30/EU and 2011/65/EU.
CANDY HOOVER GROUP S.r.l. Via Privata Eden Fumagalli, 20861 Brugherio (MB) Italy
GETTING STARTED
By following this step-by-step guide your new Hoover polisher will be ready for use:
Remove polisher and accessories from packaging.
Please dispose of the packaging in a safe and environmentally conscientious way.

HANDLE ASSEMBLY

Join together the 2 handle sections ensuring that the stud locates in the hole. (Fig. 1)
Fit the handle into the socket at the rear of the hood and push until it locates in the hole (indicated
by a "click"). (Fig. 2)
OUTER BAG ASSEMBLY
Attach bag support to the hook positioned under the hand grip. (Fig. 3)
Once the bag support is attached, insert plastic flange at the bottom of bag into the opening located
at the rear of the hood. (Fig. 4)
FITTING THE PAPER DUST BAG*
Refer to the following instructions for models equipped with paper dust bag*:
1) Open fastener on outer bag to the fullest extent to expose the air-duct.
2) Fit paper dust bag by pushing the cardboard collar on the air-duct. (Fig. 5)
3) Tuck paper dust bag into the outer bag and fully close the zip fastener.
FITTING BRUSHES
SAFETY WARNING: The polisher must be switched off and the plug disconnected from the
electrical supply before fitting or changing the brushes.
Turn the polisher upside down. Place each brush or pad on its axle and press until a click indicates
that it is the correct position. To remove brushes or pads, grasp them and pull towards you. (Fig. 6)
Your polisher is now ready for use.
USING YOUR CLEANER
Ensure the handle is in the upright position before inserting the plug into the electricity supply.
To start the polisher push the handle down then lower it into the working position.
To stop the polisher simply return handle to the upright position.
* Certain Models Only
4