if Problems occur...
Problem
My own voice is distorted when
using the headset.
The voice of the person calling me is
distorted when using the headset.
when my phone rings, I can't hear it
in my headset.
My phone doesn't react when I press
"accept call" on my headset.
There is no tone in my headset
when I press the headset button on
my phone.
There is no sound when I record.
My own voice is distorted when
recording.
The voice of the person calling me is
distorted when recording.
There is a constant noise on my re-
cording, on top of the conversation
The ring sensor is in the way, when I
use my handset
14
What.to.do
Microphone sensitivity has to be
adjusted down. See headset manual.
The speaker output on the desk-
phone has to be turned down.
check the connection between the "
Ring.tone.sensor " and the Link;
or the ring tone on the phone has
to be turned up.
please check the " COM or
headset.and AUX." connection to
the phone and headset base.
please check the " COM or headset "
connection to the phone.
check the connection between the
hub and the Dictaphone device.
Microphone sensitivity has to be
adjusted down. See headset manual.
The speaker output on desk-phone
has to be turned down.
This could be a power line interfer-
ence problem - please verify that
your recording device is not pow-
ered by a power supply supplied
from 230VAc/110VAc.
If your phone is either an Avaya 96xx
series or the Shoretel range, you can
try placing the sensor on the back of
your phone, aligned with the center
of the sound outlet.
usiNg dictaPhoNe outPut
The dictaphone output can be used to record a conversation in both
directions. A 2,5 mm Jack to 3,5 mm Jack cable is not included but
can be ordered as an accessory (part Number 14201-21).
cleaNiNg the Jabra liNK
only use a soft – and, if necessary, slightly damp – cloth for cleaning
the Jabra LINK. Do not use any solvents or cleansing agents as these
can damage the varnish of the Jabra LINK.
Further.information
If the problem persists, please visit www.Jabra.com or contact your
local Jabra agent for assistance.
Never repair or attempt to repair the units yourself, as this will
invalidate the warranty.
safety iNstructioNs
– Keep children away from the Jabra LINK. when playing, children
can be strangled by the cables.
– Do not use the Jabra LINK in a damp or dusty environment.
sPecificatioNs
Jabra LINK EHS Adapter = 44 gram/1.41 ounces
Dimensions
Height = 20,45 mm/0.81 inches
width = 50 mm/1.97 inches
Length = 100 mm/3.84 inches
regulatioNs
This product is cE marked according to the provisions of the r &
TTE Directive (99/5/Ec). Hereby, gN Netcom A/S declares that this
product is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/Ec. for further information
please consult http://www.jabra.com.
Patent.and.Design.Reg..pending.international.
15