Cleaning Method - Uline ZEBRA QLN320 Manual Del Usuario

CAUTION: To avoid possible personal injury or
damage to the printer never insert sharp or
pointed objects into the printer mechanism.
AREA
Printhead
Platen Surface
Linerless Platen Surface
Peeler Bar
Scraper (Linerless units only)
Tear Bar
Exterior
Interior
Interior of units with Linerless
Platens
Bar Sensor
Printhead Elements
Label Present Sensor
PAGE 8 OF 30
CLEANING THE PRINTER

CLEANING METHOD

Use the supplied cleaning pen to clean the print elements from end to
end.
Rotate the platen roller and clean it thoroughly with the cleaning pen.
Units with linerless platens: rotate platen and clean bearing points only.
Avoid use of alcohol on the surface of the linerless platens.
Clean thoroughly with the cleaning pen.
Clean thoroughly with the cleaning pen.
Clean thoroughly with the cleaning pen.
Wipe with water-dampened cloth.
Brush/air blow. Ensure the Bar Sensor, Gap Sensor and Label Present
Sensor are free of dust.
Clean inside surfaces of Media Supports and Media Support Disks with
the supplied cleaning pen or 70% isopropyl alcohol on a cotton swab.
Peeler Bar
Platen Surface
Gap Sensor
Tear Bar
INTERVAL
After every five rolls of media, or
more often, if needed. Linerless
media requires more frequent
cleaning.
As needed.
After every five rolls of media, or
more often, if needed.
As needed.
After every five rolls of media, or
more often, if needed.
Linerless View
Bearing Points
(Linerless Platens only)
Scraper
Media Support Disks
(Linerless Platens only)
0715 IH-3901