Charging The Battery; Connecting To Power - Uline ZEBRA QLN420 Manual Del Usuario

CHARGING THE BATTERY

1. Plug the SC2 charger into the AC outlet.
2. Insert the battery pack in the SC2 charger.
(See Figure 4)
3. The LED on the front of the charger will indicate the
battery pack's charge status. (See Figure 4)
NOTE: Green indicates fully charged, yellow
indicates charging and amber indicates
a fault. When the SC2 is plugged in but no
battery is present, the LED charge indicator will
be green.
CONNECTING THE AC POWER ADAPTER
NOTE: Batteries are shipped uncharged. Allow
batteries to charge completely prior to initial
use.
1. Open the protective cover on the printer to expose
the DC charger input jack. (See Figure 5)
2. Connect the appropriate AC power cord for your
geography to the adapter and then plug the power
cord into an AC receptacle. (See Figure 5)
PAGE 4 OF 30
QLN420 BATTERY CONTINUED
Figure 4

CONNECTING TO POWER

Figure 5
4. A second LED will indicate the health of the battery
pack. (See Figure 4)
NOTE: Green indicates good, yellow indicates
capacity diminished, yellow flashing indicates
past useful life and amber indicates unusable.
If the LED is off, there is either no battery or
power present.
Battery Pack
3. Plug the barrel plug from the AC adapter into the
charger jack on the printer. (See Figure 5)
4. The printer will power up and begin charging. The
printer can be left on or turned off at this point.
Charging will continue in either state, and the
charge status will be monitored by the LED indicator
on the front of the printer.
DC Input Jack
Charge Status Indicator
Health Status Indicator
QLN420
AC Adapter
0615 IH-4707