hose.
EN
21. CAUTION: Do not open the housing under
any circumstances. Do not insert fingers
or foreign objects in any opening of the
appliance and do not obstruct the air vents.
The unit should have good ventilation.
The ventilation slots shall be kept clear
for the unit to work properly and prevent
dangerous overheating. Do not cover the
appliance.
22. DO NOT immerse the unit in water. Do
not touch with wet hands. Do not use near
water.
23. DO NOT place the appliance in direct
sunlight or enclosed space where ventilation
is restricted, or where there are other heat
sources.
24. Do not expose to rain, wet and damp
conditions.
25. Do not operate the appliance if it is visibly
damaged.
26. Do not re-charge the product in wet or
damp conditions.
27. D a n g e r o f e l e c t r i c s h o c k ! D o n o t
disassemble. Do not attempt to repairs
or modifications. Improper repairs can
lead to considerable hazards. In case of
malfunction, repairs are to be conducted by
qualified personnel only.
28. Do not reach if the product has fallen into
liquid.
29. The supply voltage shall be the same as
that indicated in the technical specifications
and the appliance rating plate.
WARNINGS FOR BATTERIES
1.
This appliance contains batteries that are
non-replaceable. If a battery is depleted
naturally, discard the product.
2.
The battery must be removed from the
appliance before it is scrapped.
3.
The appliance must be disconnected from
the supply mains when removing the
battery.
4.
During decommissioning remove the
battery cell for recycling separately to
the product, which is covered by the
waste electrical and electronic equipment
directive. Insulate the terminals with
adhesive insulating tape to prevent a short
circuit, fire or explosion occurring.
5.
The battery is to be disposed of safely.
6.
Do not crush, open or burn the battery.
Exposure to potentially harmful materials
may occur.
7.
The battery must be charged by a constant
current, constant voltage transformer.
8.
Do not expose to high temperatures ≥ 60°C.
Battery may degrade at high temperatures.
PART LIST
30
1.
LED light
2.
Ventilation holes
3.
Hose interface
4.
Type-C USB charging port
5.
USB output port
6.
Display screen
7.
Power button
8.
Measured pressure value
9.
Battery power
10. Units
11. Progress bar
12. Pre-set pressure value
13. Application scenario
14. Unit toggle / LED
light