Porcher Slate 89810-00 Instrucciones De Montaje E Instalación página 3

2
SLATE SINK or VESSEL INSTALLATION onto VANITY...
Determine which sink is being installed and follow the instructions provided with the fixture for cut-out of vanity top
NOTE: PORCHER is not responsible for cut-out errors when the incorrect cut-out perimeter is used.
Use the specific manufacturers installation instructions provided with sinks to install drop-in or above counter style sinks.
IMPORTANT: DRAIN POSITION IS DETERMINED BY P-TRAP CUT-OUT IN UPPER DRAWER.
Center sink cut-out horizontally on the vanity top and align center of drain hole in sink with proposed drain location.
See FIGURE 2.1 for dimensions to locate center of sink.
Before cutting the opening check that distance to the finished wall allows for the faucet installation.
Place the sink centered left to right on the vanity. See FIGURE 2.2
FIGURE 2.1
Units : Inches (mm)
DASHED LINE
INDICATES
UPPER DRAWER
FIGURE 2.2
SINK CUT-OUT
Follow specific
instructions
outlined by
basin instructions
11 1/2
(292)
16
(406)
VANITY TOP
P-TRAP CUT-OUT
IN UPPER DRAWER
PROPOSED CENTER
DIMENSION TO
POSITION GRID
DRAIN (DETERMINED
BY UPPER DRAWER P-TRAP CUT-OUT)
16
(406)
NOTE:
ALIGN SINK DRAIN (SINK CUT-OUT
TEMPLATE) WITH GRID DRAIN LOCATION
BAVAGGI BASIN
Model No. 32710-00
(shown as example)
Drill 1-3/8" (35mm)
hole into Vanity Top
for Mono-block faucet
SLATE VANITY
(shown with drawer's
re-installed)
- 3 -
BAVAGGI BASIN
Model No. 32710-00
(shown as example)
7 3 0 1 2 9 2 - 1 0 0