Glacier bay 67369-0001 Guía De Uso Y Mantenimiento página 8

Installation (continued)
7
Installing the soap dispenser
□
Insert the body assembly (L) through the
selected hole in the sink. Secure the body
assembly (L) to the sink with the nut (M).
□
From under the sink, screw the bottle (N)
onto the body assembly (L) shank. Insert the
pump (K) down into the body assembly (L).
K
L
M
N
8
Making the waterline
connections
NOTE: The hot side inlet tube is indicated by a label.
If the label is not present, the hot supply tube is the longer
of the two inlet tubes.
□
Use 1/2 in. I.P.S. faucet connections (2), or use
supply line coupling nuts (3) (not included) with
a 3/8 in. O.D. ball-nose riser (1).
1
3
NOTE: Before tightening the faucet connector to the water
supply, apply a second wrench to the supply tube tting.
This will prevent the supply tube from moving or twisting
when tightening the faucet connector. Do not overtighten.
8
2