Important; Agitator Assembly - Kenmore 116.21514 Manual De Uso

TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacu-
um cJeanert the agitator must be cleaned
every time the belt is changed.
The agitator must also be cleaned accord-
ing to the following schedule=
Vacuum Cleaner Use Clean A_ilator
HEAVY - every week
(used daily)
MODERATE - every month
(used 2-3 times/week)
LIGHT - every 2 months
(used 1 time/week)
IMPORTANT
Disconnect vacuum cleaner from electrical
outlet. Check and remove hair, string and
lint build-up frequently in the PowerMate
agitator and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area,
Carefully remove
any string or
debris located
on the agitator
or end caps.
AGITATOR ASSEMBLY
End Cap
Unit End Cap
TO REPLACEBELT
NOTE: Use replacement belt STYLECB-3,
see part number detail in REPLACEMENT
PARTS(page 6).
1. Install new __r
belt over
motor drive,
then over belt
path.
2. Place agi- _\_'_'_. Drive
tatar assem- \ _'-_-_\.\ BeltPath
bly back tnto Agitator EndCap
PowerMate.
3, Verify that end
cap aspressed
firmly into position.
3. Line up front of cover and base. Rest
cover on front edge of base as shown.
Cover
___k_ 4. Rotate cover
__ back. Press cover
U_!'__-_ farmty unti[ side
and rear latches
Side Rear snap into place.
Latch Latches
Make sure there is no gap between the
cover and base.
5. Turn PowerMateupsidedown and
replace two (2) cover screws.
24