Kenmore 116.21514 Manual De Uso página 26

Review this table tofinddo-it-yourself
solutions for minor performance problems. Any other
service needed should be performed by a Sears or other qualified service agent.
4 kWARNING
Always turn off and unplug vacuum cleaner before performing maintenance to the
vacuum cleaner. Failure to do so could result in electrical shock or personal injury,
IIIIII II II
Vacuum cleaner won't
start.
Poorjob of dkt
pick-up,
Vacuum cleaner starts
but shutsoff,
PowerMate will nat
run when attached.
2. Trippedcircuit breaker/blown
fuse at householdservicepanel.
3. Loosehoseelectrteal
connections,
Unplugged at wall outlet, 1. Plug in firmly, pusF, ON/OFF switch
to on.
2. Reset circuit breaker or replace fuse.
1. Full or clogged dust bog.
2, Clogged airflow passages,
3. Dirty filters.
4. Wrong pile height settir.g,
5. Wrong power ievel se]ected_
6, Hole in hose.
Z Worn PowerMate agitator.
8. Worn or broken belt.
9. Dirty agitator or end caps,
10, Tripped overload protector in
PowerMate,
1. Hose or hood electrical
connections,
2. Tripped overload protector in
PowerMate.
3, Trippedthermal protector
in canister.
1. PowerMateconnections
unplugged,
2. Worn or broken bell
3. Dirty agitator or end caps.
4. Tripped overload protector in
PowerMate.
5. Switch r.ot in CARPET position.
3. Reconnect hose ends, (page 8)
2.
3.
4.
5.
6.
7.
8&9.
Change bag. (page 20}
Clear airflow passages.(page 19)
Clean/replace filters. (page 21-22)
Adjust setting. (page 13)
Adjustcontrol.(page tt)
Replacehose.
Change agitator. [page 23-26)
See BELT CHANGING AND
AGITATOR CLEANING (page 23-24).
10. _emove any itemsthat may be
caughtor jammed_thenreset. If
vacuumcleanerstarts and stops
again, clean agffator and end capsj
then reset.(page 18, 25)
1. Check connections, r econnecthose
ends.(page 8)
2. Remove any itemsthat may be
caughtor jammed_then reset. If
vacuumcleanerstarts ar.d stops
again, clean agltator and endcaps,
then reset.(page 18)
3. See PERFORMANCE FEATURES -
=l'hermaI Protector"(page t8).
Plugin firmly.
I.
2&3.
4.
See BELT CHANGING AND
AGITATORCLEANING [page 23-24).
Removeany itemsthat may be
caughtor jammed, then reset. If
vacuumcleaner starts and stops
again, clear, agitator and end caps,
then reset. [page 18, 25)
Move switchto CARPETposition.
[page 11)
26