Descargar Imprimir esta página

Publicidad

Enlaces rápidos

Surge Protector
Instructions
Temporary Installation:
1. Remove the mounting screw from the surge protecter that is needed for
permanent installation.
2. Plug the surge protector into a standard grounding duplex wall receptacle,
covering both outlets, by fully inserting the plug and ensure that there are
no exposed conductors.
3. The surge protector will now be providing power and surge protection.
4. Make sure electronic equipment is turned off before plugging into the
surge protector outlets. Do not use extension cords to connect equipment
to the surge protector.
5. Connected equipment can now be turned on.
6. Hold the surge protector firmly against wall when removing plugs to
prevent it from pulling loose.
Permanent Installation:
1. Disconnect power to the receptacle at the service panel.
2. Remove wall plate from existing grounded duplex wall outlet and discard.
3. Plug surge protector into wall outlet and secure with center mounting
screw provided.
4. Restore power at service panel.
5. The surge protector will now be providing power and surge protection.
6. Make sure electronic equipment is turned off before plugging into the
surge protector outlets. Do not use extension cords to connect equipment
to the surge protector.
7. Connected equipment can now be turned on.
NOTE: Check the blue "PROTECTED" indicator light periodically. A glowing
blue indicator light shows that surge protection is being provided. If the blue
"PROTECTED" indicator light stops glowing, the surge protective components
have expired* and power will permanently shut down to the outlets to ensure
the protection of your electronics.
Surge Protector — Limited-Lifetime Warranty
Jasco Products Company warrants this surge protector to be free of defects
in workmanship and/or materials for the life* of the surge protector. If such
a defect should arise during the life of the surge protector, Jasco Products
Company will, at its option, either repair or replace the surge protector
without charge. This warranty does not cover damage caused by lightning,
accident, misuse or alterations to the surge protector.
* This surge protector, like all surge protectors, has a finite lifespan. Even
under normal circumstances and in the absence of defects, the product's
life will expire when the surge protector's component capacity has been
exceeded, thereby ceasing to provide protection from surges. In this event,
the Limited-Lifetime Warranty is no longer valid and the surge protector
should be replaced.
Warranty replacement procedure
1. Call Jasco Products Company Customer Information Center at
1-800-654-8483 to get a Return Authorization Number (RA#), shipping
instructions and a prepaid return address label.
2. After you have received the prepaid return address label, return the Jasco
Products Company surge protector, freight prepaid, to Jasco Products
Company. Surge protectors returned to Jasco Products Company must
have an RA# included in the mailing address to be accepted.
3. The original purchaser will be asked to send the surge protector, a copy of
the sales receipt for the product, your name, address, phone number and
a description of the problem.
Connected Equipment Warranty
Equipment Replacement Guarantee for Surge Model: 38431
Maximum Warranty Amount: $50,000(USD)
NOTE: This device is not a lightning arrestor, so it will not afford protection
when lightning strikes nearby power line, the house, service entrance
or antenna. The Warranty is void if a power disturbance damages your
equipment through the coax, phone or network lines.
Jasco Products Company will pay up to the maximum warranty amount
offered for the surge protector purchased to repair or replace up to an
amount equal to the fair market value or the original purchase price,
whichever is less, of your electronics equipment, if damaged by a transient
surge (except those caused by direct lightning), within the life* of the surge
protector, while properly and directly connected to this surge protector.
JASCO PRODUCTS COMPANY DISCLAIMS AND ASSUMES NO LIABILITY FOR
ANY OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT
NOT LIMITED TO LOSS OR DAMAGE TO SOFTWARE OR DATA OR DAMAGES OR
COSTS ASSOCIATED WITH BUSINESS INTERRUPTION OR OTHER DAMAGES DUE
TO LOSS OR DAMAGE TO EQUIPMENT, SOFTWARE OR DATA. Some states do
not allow the exclusion or limitation of incidental or consequential damages,
so the above limitation or exclusion may not apply to you. This warranty
gives you specific legal rights, and you may also have other rights that may
vary from state to state.
This warranty is secondary to any existing coverage of any connected
equipment, including but not limited to, any manufacturer's warranty,
extended warranties or insurance coverage.
To qualify for a connected equipment warranty:
1. All connected equipment must be UL and/or CSA approved.
2. The Jasco Products Company surge protector must be plugged into
properly wired and grounded outlets, no extension cords, adapters, other
ground wires or electrical connectors may be used, with the sole exception
of other standard Jasco Products Company 120 volt products approved
for that use. The installation must comply with all applicable electrical and
safety codes set forth pursuant to the National Electrical Code (NEC).
3. Any claim under the warranty policy must be made within 15 days of the
date of the alleged damage to the connected equipment.
For connected equipment coverage, the following conditions must
be satisfied:
A) All equipment eligible for warranty coverage must be plugged directly
into the Jasco Products Company surge protector. Equipment connected
to the protected equipment, but not plugged directly into the surge
protector will not be covered.
B) The equipment must have been damaged by a covered power disturbance
that passed through the Jasco Products Company surge protector.
C) The Jasco Products Company surge protector must be damaged from the
power disturbance.
D) The Jasco Products Company surge protector's protection capacity must
not have been exceeded.
Connected equipment claim procedure:
1. Call Jasco Products Company Customer Information Center at 1-800-654-8483
to get a Return Authorization Number (RA#), shipping instructions and a
prepaid return address label.
2. After you have received the prepaid return address label, return the Jasco
Products Company surge protector, freight prepaid, to Jasco Products
Company. Surge protectors returned to Jasco Products Company, Inc.
must have an RA# included in the mailing address to be accepted.
3. Jasco Products Company will determine whether the damage to your
equipment is covered by this warranty policy. If you are covered, a claims
adjuster will contact you and Jasco Products Company will do one of the
following at its own discretion:
a) Authorize a service center to repair damaged equipment.
b) Replace damaged equipment with equivalent or better.
c) Reimburse customer the fair market value of the damaged equipment.
d) Reimburse customer the initial purchase price of the damaged
equipment (customer to provide dated bill of sale).
4. Jasco Products Company retains the right to determine whether the
damage to the connected equipment is due to Jasco Products Company
surge protector failure by requesting that damaged equipment be sent to
Jasco Products Company for inspection.
FCC Statement
Notice: Federal Communications Commission (FCC) requirements, Part 15
This equipment has been tested and found to comply with the limits for a class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes of modifications not expressly approved by the
grantee of this device could void the users authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
WARNING
RISK OF ELECTRIC SHOCK
TO REDUCE THE RISK OF ELECTRIC
• DO NOT USE IN WET LOCATIONS
SHOCK - DISCONNECT POWER
• KEEP CHILDREN AWAY
TO THE RECEPTACLE BEFORE
• USE INDOORS ONLY
INSTALLING OR REMOVING THE
• FULLY INSERT PLUG
UNIT. WHEN REMOVING THE COVER
• DO NOT USE WITH METAL WALL
SCREW, COVER MAY FALL ACROSS
PLATES
PLUG PINS OR RECEPTACLE MAY
RISK OF FIRE
BECOME DISLODGED. DO NOT USE
• DO NOT EXCEED ELECTRICAL
THIS DEVICE WITH A RECEPTACLE
RATINGS
IN WHICH THE SLOT OPENINGS DO
NOT FOR USE WITH
NOT ALIGN WITH THE BLADES. NOT
• AQUARIUMS OR OTHER WATER-
FOR USE WITH RECEPTACLES THAT
RELATED PRODUCTS
CONTAIN GROUND-FAULT CIRCUIT
• GENERATORS AND POWER INVERTERS
.
INTERRUPTERS, INDICATOR LIGHTS,
• MEDICAL LIFE-SUPPORT PRODUCTS
OR CONTROLS. USE ONLY WITH
DUPLEX RECEPTACLE HAVING CENTER
SCREW. SECURE UNIT IN PLACE WITH
SCREW PROVIDED.
MADE IN CHINA
GE is a trademark of General Electric Company and is
under license by Jasco Products Company LLC, 10 E.
Memorial Rd., Oklahoma City, OK 73114.
This Jasco product comes with a limited-lifetime
warranty. Visit www.byjasco.com for warranty details.
Questions? Contact us at 1-800-654-8483
between 7:00AM—8:00PM CST.
CAUTION
.
38431 ver. 1
12/28/16 KN

Publicidad

loading

Resumen de contenidos para GE 38431

  • Página 1 Products Company surge protector, freight prepaid, to Jasco Products must have an RA# included in the mailing address to be accepted. GE is a trademark of General Electric Company and is Company. Surge protectors returned to Jasco Products Company must 3.
  • Página 2 Jasco Products Company tomará una de las siguientes Instrucciones del supresor medidas a su total discreción: Garantía de reposición de aparatos para el modelo de supresor: 38431 a) Autorizará que un centro de reparaciones repare el equipo dañado. Importe máximo de la garantía: USD 50,000 de sobretensiones b) Cambiará...