Operating The Device Safely - Waeco CoolMatic HDC155FF Manual De Instalación Y Funcionamiento

HDC155FF
 Set up the device in a dry location where it is protected against
splashing water.
2.2

Operating the device safely

DANGER!
D
 Do not touch exposed cables with your bare hands.
CAUTION!
!
 Before starting the device, ensure that the power supply line
and the plug are dry.
 If you connect the device to a battery, make sure that no food
comes into contact with the battery acid.
NOTICE!
A
 Do not use electrical devices inside the cooling device unless
they are recommended by the manufacturer for that purpose.
 Do not place it near naked flames or other heat sources
(heaters, direct sunlight, gas ovens etc.)
 Danger of overheating!
Always ensure sufficient ventilation so that the heat generated
during operation can dissipate. Make sure that the device is
sufficiently far away from walls and other objects so that the air
can circulate.
 Ensure that the ventilation vents are not covered.
 Do not fill the inner container with ice or fluid.
 Never immerse the appliance in water.
 Protect the appliance and the cable against heat and moisture.
 Make sure that foodstuffs do not touch the walls of the cooling
area.
EN
Safety instructions
37