Makita 2414DB Manual De Instrucciones página 5

Interval between vise and guide
plate
4
► 1 . Socket wrench 2. Guide plate 3. Move 4. Hex
bolts
The original spacing or interval between the vise and
the guide plate is 0 - 170 mm (0 - 6-11/16"). If your work
requires wider spacing or interval, proceed as follows to
change the spacing or interval.
Remove the two hex bolts which secure the guide plate.
Move the guide plate as shown in the figure and secure
it using the hex bolts. The following interval settings are
possible:
35 - 205 mm (1-3/8" - 8-1/16")
70 - 240 mm (2-3/4" - 9-7/16")
CAUTION:
• Remember that narrow workpieces may not be
secured safely when using the two, wider inter-
val settings.
Setting for desired cutting angle
1
2
3
3
► 1 . Socket wrench 2. Guide plate 3. Hex bolts
To change the cutting angle, loosen the two hex bolts
which secure the guide plate. Move the guide plate to
the desired angle (0° - 45°) and tighten the hex bolts
securely.
CAUTION:
guide plate is set at the 35 - 205 mm (1-3/8" - 8-1/16")
or 70 - 240 mm (2-3/4" - 9-7/16") position.
CAUTION:
the material is not firmly secured with the vise
because of the cutting angle.
ASSEMBLY
CAUTION:
•
Removing or installing cut-off wheel
► 1 . Shaft lock 2. Safety guard 3. Socket wrench
To remove the wheel, raise the safety guard. Press the shaft
lock so that the wheel cannot revolve and use the socket
wrench to loosen the hex bolt by turning it counterclockwise.
Then remove the hex bolt, outer flange and wheel. (Note:
Do not remove the inner flange, ring and O-ring.)
To install the wheel, follow the removal procedures in
reverse.
5 ENGLISH
Never perform miter cuts when the
Do not operate the tool when
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
1
1
2
2
3