Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6. Technical data
Load capacity
Drum clamp
clamping range
Overall height
(mm)
Lifting height (mm)
Type
Oil fill volume
(litres)
7. Operation
Fitting to the drum
Check first of all that the drum is suitable, clean and undamaged. Check the edge of the drum in
particular.
9. Approach the drum to be loaded centrally with the drum lifter.
10. The drum clamp opens and closes automatically.
11. Lift the clamp to the level of the upper rim of the drum.
12. Adjust both sides simultaneously with the adjusting screw (1) until the
grippers fit against the wall of the drum. The sticker on the frame (3) can
be used to make sure both sides are adjusted evenly.
13. Lock the adjusting mechanism with the locking ring (2).
14. Lift the drum a little and then lower it in short jerky steps to check it is
securely held.
15. Lift the drum using the hand crank or the hydraulic pump.
16. The drum lifter is now ready to transport more of the same type of drum
without further adjustment.
Drum transport
Pull/push the drum lifter using the handle to the new location.
Drums should only be slightly raised when being transported.
Avoid shaking the drums.
Do not use on sloping surfaces!
Setting down the drum
3.
Lower the drum gently by releasing the release screw or turning the hand crank anti-clockwise.
4.
The drum clamp will release automatically as soon as the drum touches the floor.
Faults (drum lifter with hydraulics)
If the drum lifter does not lift the load, there may be air bubbles in the hydraulic system. The procedure for
removal of air bubbles is described in section 5 (Setting up and initial operation).
Fasslifter LD-SK
201867
300kg
530 – 610mm
1260
500
with hydraulic pump
0.8
Seite 7 von 15 Seiten
Ausgabe 11/2013
Publicidad
Tabla de contenido
