iSi Dessert Whip. PLUS Modo De Empleo página 10

5. Too many chargers were used:
Pay attention to the maximum number
of chargers to be used indicated in the
Whipper Data.
„Release the pressure" and then set­up
again.
The content being dispensed is too runny.
1. The whipper was overfilled:
„Release the pressure", pour out the ex­
cess liquid and then set­up the whipper
again.
Observe the maximum filling amounts.
2. The Whipper was not shaken or not shaken
enough:
For information on the frequency of the
shaking cycles, refer to www.isi.com/
home­edition/whippedcream.
3. The content is not cold enough:
Place a filled and prepared iSi whipper in
the refrigerator for at least 1­2 hours.
4. An unsuitable charger was used:
Only use original iSi cream chargers.
The cream charger will not puncture.
1. The charger being used is not suitable:
Only use original iSi cream chargers.
2. The charger was inserted backwards:
Insert the charger correctly
(see diagram: Instructions for Use).
3. The puncturing unit has been damaged:
Send the whipper to iSi or to a
service center.
During operation, gas is leaking through the
dispensing piston or adapter.
1. The device was used without the adapter:
Before screwing on the charger, make
sure that the adapter is attached
to the dispensing piston.
„Release the pressure" and then set­up
the whipper again.
2. The dispensing piston seal has been damaged:
The dispensing piston needs to be
replaced and is available as an original
iSi spare part.
12
During operation, gas is leaking between the
bottle and the head.
1. The head gasket is missing:
„Release the pressure" and insert the
head gasket into the head.
2. The head gasket has been damaged:
„Release the pressure." The head gasket
needs to be replaced and is available as
an original iSi spare part.
3. The head was not tightened securely:
„Release the pressure"
Tighten the head on to the bottle by
hand as per the instructions.
4. The bottle has been damaged on the upper
edge:
„Release the pressure" and send the
whipper to iSi or a service center.
Service.
Replacement parts are available individually
and at an affordable price.
See your specialist dealer for the availability
of replacement parts. In Austria, you can also
get in contact via info@isi.com. In the US con­
tact isinorthamerica@isi.com
Only send in the complete whipper for repairs.
Replacement parts can be seen in greater
detail on the expanded drawing.
13
EN