Remote Control - Q Acoustics m2 Manual De Instrucciones

4. Remote control

a. Power
Press this button to turn the Unit STANDBY ON/OFF.
b. Source select
Press this button to manually select the audio input source.
The status LED will change colour accordingly.
Important Note: When the Source button is used, the Unit
will stay on the selected source and disable the Intelligent Pre-
Amplifier (IPA) automatic source selection. IPA functions will be
reactivated after the Unit has been put in STANDBY.
c. Volume Up / Down
Press VOL + to increase the volume. Press VOL – to reduce
the volume.
d. Mute
Press this button once to MUTE the Unit. Status LED will
SLOW FLASH to indicate MUTE. Press this button again to
un-mute the Unit.
Please Note: Long press of Mute will also put the Unit into
STANDBY.
e. EQ
Short press the EQ button to toggle MoviEQ
the Yellow LED flashes and remains on, MoviEQ
Remote Control battery replacement
Caution: When replacing the lithium battery in the remote, make sure that the replacement battery is
inserted with the correct polarity. Place the battery so that the positive (+) side faces up with the tray held so
the surface with the dot and (+) is facing up.
a. Push small tab
toward battery slot.
Caution: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent battery type (CR2025)
Warning: Do not expose batteries to excessive heat such as direct sunlight, fire or the like.
Dispose of dead batteries in accordance with local regulations.
On and Off. If
™
™
b. Pull battery
drawer out.
is On.
c. Insert battery
with "+" side up
and slide drawer
back into remote.
15
a
b
c
d
e
d. Slide drawer
back into remote.