Auto Source Select; Low Source Gain (Lsg ™ ) - Q Acoustics m2 Manual De Instrucciones

5.3. Bluetooth
®
• ON time is determined by the AVRCP response time of your Bluetooth
connected, and you press Play it can take between 1-5s.
• OFF time is determined by the AVRCP response time of your Bluetooth
Bluetooth off, or disconnect your device it can take between 1-3s.
®
5.4. Line In 1 / 2
• ON time is determined by the audio signal level; when the signal level is audible it can take between
1-3s.
• OFF time is determined by the audio signal level; when the signal level is not audible it will take 20
minutes.
Please Note: If the user places the Unit in STANDBY while a source is still playing, the AUTO ON function
will be disabled until the source is stopped. This will prevent the Unit from unwanted AUTO ON.
For Line In 1/2 the signal must be at a not audible level for 20 minutes before the Unit AUTO ON will
function.
6.

Auto source select

The IPA follows a priority list for connected audio sources. A connected HDMI
™
has the highest priority, followed by Optical, then Bluetooth
Important Note: The IPA
the user. Simply press the SOURCE SELECT button on the remote, or a short press of the STANDBY
Button on the Unit.
The IPA will reactivate once the Unit has been put into STANDBY.
™
7. Low source gain (LSG
During our extensive testing we found that on a number of manufacturer's equipment the digital signal
output level is lower than the expected Full Scale (FS). To allow our users to get the best audio experience
from the Q Acoustics Unit we have included a LSG
The LSG switch can be found on the Rear Panel, and has two settings.
™
1 = Normal gain
2 = Increased 6dB of gain for Optical and HDMI
HDMI ARC
™
Optical input
Bluetooth
®
Line in 1
Line in 2
Standby
can be overridden at any time by a simple manual SOURCE SELECTION from
™
)
™
INPUT
PRIORITY
and finally Analogue 1 and 2:
®
switch.
™
sources
™
17
device; once your device is
®
device. Once you turn
®
source that starts to play
™