Forch 6620 0047 Manual De Instrucciones página 10

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
GUN WITH PRESSURE TANK FOR HOLLOW
ENG
SPACES
Proper use
- The GUN WITH PRESSURE TANK FOR HOLLOW SPACES is used to apply spray
agents in hollow spaces in connection with spray hoses for hollow spaces
- Using the hoses for spraying it is possible to easily reach all hollow spaces.
- A closed sealing is realized by the pressure process and the additional spray air
admission.
For your safety
- Safe working on the device is only possible, if the operating instructions and safety
guidelines are completely read and the included instructions are strictly observed.
- Be practically instructed before the first use.
- Check the device before each use.
- Have damages repaired only by a specialist.
- Any modifications or retrofitting on the device are forbidden.
- Only use original accessories.
- Only operate the device at admitted pressure.
- Do not spray against flames or burning objects.
- The working places must be light, well-ventilated and comply with the applicable
regulations for hygiene and operational safety.
- Do not inhale spray.
- Keep device and accessories away from children.
Device parameters
Max.-pressure: 8 bars
Operating pressure: 2 to 6 bars
Filling quantity: 1 liter
Safety guidelines
- Check the function of the gun before use.
- Nozzle head (19) and standpipe (31) must be unobstructed at any time.
- Check, if there are any visible damages on the gun.
- Observe the existing guidelines, respectively safety regulations when handling
chemical agents.
Commissioning
- Check the line pressure in the compressed air network and adjust it, if required.
- It is imperatively necessary to use only clean, dry air for optimum function of the
compressed air tool. This can be achieved by using a water and oil separator in the
compressed air system, which also considerably improves the spray behavior.
Instructions / Use
- Fill compressed air tank (32) with spray agent.
- Immerse gun body with standpipe in the spray agent and screw a tank underneath
the gun.
- Press spray hose for hollow spaces with straight jet nozzle or spray hose for hollow
spaces with angled nozzle with plug into the quick-action coupling (20).
- Connect gun to the compressed air network. Actuate the trigger to stage 1 and
check, if spray air is leaving at the nozzle opening.
- Adjust the material quantity by means of the stop screw (7).
Depending on the material, it is possible to achieve an optimum spray pattern with t
this adjustment.
- Insert the spray hose with straight spray nozzle into the hollow space and slowly
extract it, at this actuate the trigger of the gun. Shortly before the straight air nozzle
leaves the hollow space, release the trigger (this way, the material flow is
interrupted).

Publicidad

Tabla de contenido
loading

Tabla de contenido