Contact Informartion; Ordering Information; Replacement Parts - CMP DEL OZONE 25 Manual Del Usuario

Ocultar thumbs Ver también para DEL OZONE 25:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4 MAINTENANCE & SERVICE
To replace an Ozone Module:
1. Disconnect the manifold or tubing from the ozone module.
Note: For the Ozone 25 and Ozone 50, pull the tubing clamp back
from the ozone module barb connector, then pull the tubing from
the barb.
2. Locate the ozone module power connector and disconnect it from
the wire harness.
3. Remove the ozone module mounting screws. The ozone module
can now be removed from the unit.
4. Install the new ozone module by reversing the steps.
4D. Contact Information
For technical assistance:
• Call: 1 (800) 733-9060
• Email: support@c-m-p.com
• Or visit our website: www.c-m-p.com
4E. Ordering Information
To locate a dealer nearest you call 1 (800) 733-9060
or visit www.c-m-p.com.
Be prepared with the following information:
• Name
• Date Purchased
• Address
• Dealer Name
• Model #
4F. Replacement Parts List:
Ozone Module Kit ............................................................................... 9-1636-01
Each ozone module should be replaced after 15,000 hours of use.
Ozone Tube Assembly .......................................................................9-0770-01
The Ozone Tube Assembly (includes Ozone Tube and Check Valve) must be replaced
once a year.
Ozone Module Filter ..........................................................................9-0858-01
Replace once a year.
Note: The warranty is void if the parts listed above are not replaced at
recommended intervals.
10

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Del ozone 50Del ozone 100

Tabla de contenido