Maintenance And Cleaning; Charging The Unit - G3 Ferrari NIMBUS Manual Del Usuario

The floor vacuum cleaner is completely mounted.
- The working button (14) switches on and off the appliance.
- The speed button (15) controls the vacuuming power.
To remove vacuum cleaner (3), take the handle and press release button (9).
To remove the motorized brush (20), press release button (19) and pull the housing
(17) until it detaches from the brush. To fold the handle (13), press button (16).

MAINTENANCE AND CLEANING

EMPTYING THE DUST CONTAINER
When the dust reaches the maximum level inside the container (6), it is necessary
to remove it. For emptying the container, follow the steps below:
- Press the release button to open the dust container (8) separating the container from the main body.
- Remove the Filtering system (7) by pulling it toward you.
- Empty the container (6) into the trash and rinse it with tap water.
- Dry the container before installing it on the unit.
CAUTION: if operating on wet surfaces, always empty the container (6) at the end of the operation.
FILTER MAINTENANCE
It is recommended to periodically check the condition of the filter and if it is dirty it should be cleaned as
described in the following paragraph:
- Press the release button to open the dust container (8) and separate the container from the unit.
- Remove the Filtering system (7) by pulling it toward you.
- To remove dust from the filter, use a vacuum cleaner or wash it with tap water, being careful not to break
the filter; it is recommended to always dry it completely before replacing it
inside the container.
CAUTION: when the filter (7) runs out, contact an Authorized Service Center for
replacing it.
BRUSH MANTAINANCE
It is recommended to periodically check the condition of the brush and if it is dirty
it should be cleaned.
- Take the motorized brush (20) and turn upside down.
- Lift up the blocking lever of the rotating brush, as for Fig.4.
- Extract the rotating brush and clean it; use a vacuum cleaner or
wash it with tap water and then dry it.
- Clean the internal part of the brush (20) and the suction tube.
CHARGING
WARNING FOR A GOOD USE OF THE BATTERY
During use the charging lights (2) indicate the charge level. When the battery
is nearly discharged only one light is on and finally it flashes. This indicate
that is time to recharge.
For charging, switch off the product with power button (1), plug the adaptor
to the power outlet and connect the pin to the socket on the left side of
charging base (11).
Insert the brush in its seat in the charging base (11). The appliance must be
completely mounted. The charging lights (2) have the following behavior, if
the appliance is properly connected.
a. One light flashes: charging level is low.
b. One light on and one light flashes: charging level is more than half.
c. Two lights on and third light flashes: charging is nearly complete.
d. Three lights on: charging is complete.
13