GE 14098 Instrucciones

Surge Protector
Instructions
1. Plug the surge protector into a standard grounding
duplex wall receptacle, covering both outlets, by fully
inserting the plug. Ensure that there are no
exposed conductors.
2. The surge protector will now be providing power and
surge protection.
3. Make sure electronic equipment is turned off before
plugging into the surge protector outlets. Do not use
extension cords to connect equipment to the
surge protector.
4. Connected equipment can now be turned on.
5. Hold the surge protector firmly against wall when
removing plugs to prevent it from pulling loose.
NOTE: Check the blue "PROTECTED" indicator light
periodically. A glowing blue indicator light shows that
surge protection is being provided. If the blue "PROTECTED"
indicator light stops glowing, the surge protective components
have expired — though power will still be supplied to the
outlets, now unprotected. To ensure the protection of your
electronics, the surge protector should be replaced.
Surge Protector — Limited Lifetime Warranty
Jasco Products Company warrants this surge protector
to be free of defects in workmanship and/or materials
for the life* of the surge protector. If such a defect should
arise during the life of the surge protector, Jasco Products
Company will, at its option, either repair or replace the
surge protector without charge. This warranty does not
cover damage caused by lightning, accident, misuse or
alterations to the surge protector.
* This surge protector, like all surge protectors, has a finite
lifespan. Even under normal circumstances and in the
absence of defects, the product's life will expire when the surge
protector's component capacity has been exceeded,
thereby ceasing to provide protection from surges.
Warranty Replacement Procedure
1. Call Jasco Products Company Customer Information
Center at 1-800-654-8483 to get a Return Authorization
Number (RA#), shipping instructions and a prepaid
return address label.
2. Return the Jasco Products Company surge protector,
freight prepaid, to Jasco Products Company. Surge
protectors returned to Jasco Products Company must
have an RA# included in the mailing address to be
accepted.
3. The original purchaser will be asked to send the surge
protector, a copy of the sales receipt for the product,
your name, address, phone number and a description
of the problem.
FCC Statement
14098 ver. 1
03/15/13
Notice: Federal Communications Commission (FCC)
requirements, Part 15
This equipment has been tested and found to comply with
the limits for a class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
CAUTION: Any changes of modifications not expressly
approved by the grantee of this device could void the
users authority to operate the equipment. This device
complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must
accept any interference received, including interference
that may cause undesired operation.
CAUTION
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
USE THIS DEVICE WITH A RECEPTACLE IN WHICH THE SLOT
OPENINGS DO NOT ALIGN WITH THE BLADES. NOT FOR USE
WITH GROUND-FAULT CIRCUIT- INTERRUPTER RECEPTACLES OR
RECEPTACLES WITH INDICATOR LIGHTS OR CONTROLS.
For additional assistance or information contact
our Customer Service department at
1-800-654-8483 between 7:30AM—5:00PM CST
or via our website (www.jascoproducts.com).
MADE IN CHINA
is a trademark of General Electric Company and
is under license by Jasco Products Company LLC,
10 E. Memorial Rd., Oklahoma City, OK 73114.
www.jascoproducts.com
This Jasco product comes with a limited-lifetime
warranty. Visit www.jascoproducts.com for details.