Maintenance; Clean The Machine; Transportation And Storage; Store The Machine - GreenWorks Commercial 82B600 Manual Del Operador

EN
• Use rakes and brooms to clear the unwanted material
before you blow.
• Make the surfaces wet before you clear the unwanted
material in dusty conditions.
• Look out for children, pets, open windows, and cleaned
cars during operation.
•

Clean the machine.

• Discard the unwanted material when you complete work.
12

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
12.1 CLEAN THE MACHINE
The machine must be dry. Humidity can cause risks of
electrical shocks.
• Clear the unwanted material out of the air vent with a
vacuum cleaner.
• Do not spray the air vent or put the air vent in solvents.
• Clean the housing and the plastic components with a
moist and soft cloth.
13 TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before
tranportation and storage.
13.1

STORE THE MACHINE

• Clean the machine before storage.
• Make sure that the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service center.
CAUTION
CAUTION
WARNING
CAUTION
WARNING
English
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
14

TROUBLESHOOTING

PROBLEM
The motor does
not start when
you pull the trig-
ger.
The machine does
not start.
The air does not
flow through the
tube when you
start the machine.
15

TECHNICAL DATA

Voltage
Air volume
Air speed
Weight (without
battery pack)
Battery model
Charger model
The recommended ambient temperature range:
Item
Blower storage temperature
range
Blower operation tempera-
ture range
Battery charging temperature
range
Charger operation tempera-
ture range
8
POSSIBLE SOLUTION
CAUSE
Make sure that
The battery pack is
you tighlty install
not installed tight-
the battery pack in
ly.
the machine.
The battery pack is Charge the battery
out of power. pack.
The power switch
is defective.
Replace the defec-
The motor is defec- tive parts by an ap-
tive. proved service
center.
The PCB board is
defective.
The air inlet or
Remove the block-
tube outlet has a
age.
blockage.
82 V
640 CFM
120 MPH (193 Km/h)
5.42 lbs. (2.46 kg)
GL 400, GL 400BT and other GL/
GLW series
GC 400 and other GC series
Temperature
-4°F (-20°C) - 158°F (70°C)
-4°F (-20°C) - 104°F (40°C)
39°F (4°C) - 104°F (40°C)
39°F (4°C) - 113°F (45°C)