Orbegozo FH 5580 Manual De Instrucciones página 12

INSTRUCTIONS FOR USE
1 Turn the thermostat switch to the minimal value, at the same time turn the heat select switch to the
"O" position (see picture).
2 Plug in the appliance, and turn the thermostat switch to the maximum position. Then turn the heat
select switch to choose air or warm air and the temperature of warm air as below. While working the
indicator light will be on.
2.1 Turn the heat select switch to "
2.2 Turn the heat select switch to "I" position, the heater blows warm air, working at 1000W.
2.3 Turn the heat select switch to "II" position, the heater blows warm air, working at 2000W.
2.4 Turn the heat select switch to "O" position, the heater stops working, the indicator light will be off.
3. Adjust the thermostat switch to suitable position for desired temperature setting.
3.1 Check if the thermostat switch is on the maximum position.
3.2 When you feel the room temperature comfortable, turn the thermostat switch anti-clockwise slowly to the
minimal position until the appliance stops working.
3.3 Then the thermostat switch will keep the room temperature at the desired temperature automatically.
3.4 You can also turn the thermostat switch anti-clockwise to the minimum position or turn the thermostat
switch clockwise to maximum position to make the temperature lower or higher.
OSCILACION(FH 5580, FH 5570, FH 5560)
In order to spread the heat and to optimise the heating of room,your appliance is equipped with an
oscillation feature of +/-45° that can simply be activated by pressing the switch situated on the
base.Position I allows the appliance to rotate and position 0 blocks the rotation of the appliance in the
desired position.
Note: Products Oscillation functions only by Oscillation switch control .
OVERHEATING SAFETY DEVICE
To prevent damage and risks due to overheating, the built-in overheating safety device cuts off the power as
soon as the heating elements become too hot.
MAINTENANCE
We recommend that you clean your heater at least twice a year to remove accumulated dust and dirt.
to switch off. Remove the mains plug from the wall socket. Wait for the heater to cool down sufficiently. -You
-Set the selector switch to position
may clean the outside of the heater with a damp cloth or brush. Do not use water or allow water to
come into the appliance. Do not use any abrasive and caustic cleaning agents! -Never touch the
heater in water! Danger to life! -Clean the air inlet and outlet grilles regularly with a vacuum cleaner,
using the brush attachment.
Storage
Keep the original box in which the heater was packed to store it during the warmer months when it is not in
use. Clean the heater according to the instructions under Cleaning. Pack the heater in the original box and store
it in a cool, dry place.
"
position,
the heater
blows cool
air.