Beper BP.400 Manual De Instrucciones página 8

Multi-function grater and slicer Use instructions
Description of the product Fig. A
1. Pusher
2. Filling tube
3. Slicing cone
4. Julienne slicing cone
5. Fine grater cone
6. Coupling for cone
7. Operation button
8. Motor housing
9. Power cord
Instructions for Use Fig.B
Before the first use it is advisable to clean all the components as indicated in the paragraph "Cleaning and
maintenance".
Place the product in a vertical position on a flat and stable surface.
Select the cone to use based on the desired cut. Insert the cone into the appropriate housing, then insert the
cone coupling into the coupling for cone placed on the motor housing and turn anticlockwise to lock the compo-
nents so assembled.
Connect the power cord to the electrical outlet.
Insert the food through the filling tube, and push the food using the pusher.
It is recommended to cut the food into small pieces before processing.
Press the operation button and keep it pressed for the time necessary for complete processing of the food.
To change the cone, turn the filling tube clockwise, remove the cone in use and replace it with the desired one.
Make sure the product is switched off and unplugged before proceeding with this operation.
Cleaning and maintenance
It is recommended to clean the appliance immediately after use.
Disconnect the plug from the socket.
Remove the accessories from the motor housing.
Handle the cones with care because the blades are extremely sharp.
The parts that can be washed in water or in the dishwasher are the cones, the filling tube and the pusher.
Do not use grainy detergents and abrasive cloths; could damage the appliance.
The motor housing, the cable and the plug must be cleaned only with a damp cloth; do not immerse them or
pass them under water.
Make sure that the appliance with all its parts will be dry before using it again and before storing the product.
Technical data
Power: 430W
Power supply: 220-240V ~ 50 / 60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
8