Sunex Tools 1003 Instrucciones De Operación página 2

Operating Instructions • Warning Information • Parts Break down
OPERATING INSTRUCTIONS:
Begin by setting parking brake on vehicle and
blocking all wheels. Make sure vehicle is raised to
desired height and is stable. Extend the post to
height close to the support member. Check the load
locking and release handle to insure that the dog
portion has engaged a tooth on the post. Make
sure both jack stands are at an equal height and
will support the load equally when the lifting device
is removed. Place jack stands carefully under
support points specified by vehicle manufacturer. Do
not crawl under vehicle when placing or removing
stands! SLOWLY lower the load onto the jack
stands and check to insure the load is located on the
center portion of the post saddle. Check the load for
stability. If the load is NOT located on the center of
the post saddle, or if the load is not stable, re-lift the
load and reposition the jack stands to insure proper
loading before continuing with work or repairs.
NOTE: When using jack stands for body shop work
such as straightening of frame and/or body of
vehicle, use caster wheel type jack stand dollies to
prevent load from being pulled off jack stands. When
removing stands, carefully raise vehicle enough to
clear the stands, making sure the vehicle remains
stable. Remove stands, being careful not to crawl
under vehicle while doing so. Carefully lower vehicle
to floor.
1003/1006
10031006_081906.indd 2
Load
Locking
and Release and Release
Handle
Base
MODEL 1003/1006
3 and 6 Ton Capacity Jack Stand 3 and 6 Ton Capacity Jack Stand
Saddle
Post
Tab
LIMITED WARRANTY...
SUNEX INTERNATIONAL, INC. WARRANTS TO ITS
CUSTOMERS THAT THE COMPANY'S SUNEX TOOLS
BRANDED PRODUCTS ARE FREE FROM DEFECTS IN
WORKMANSHIP AND MATERIALS.
Sunex International, Inc. will repair or replace its Sunex Tools ®
branded products which fail to give satisfactory service due to
defective workmanship or materials, based upon the terms and
conditions of the following described warranty plans attributed to that
specific product. This product carries a 1 year warranty. During this
warranty period, Sunex Tools will repair or replace at our option any
part or unit which proves to be defective in material or workmanship.
Other important warranty information...
This warranty does not cover damage to equipment or tools arising
from alteration, abuse, misuse, damage and does not cover any
repairs or replacement made by anyone other than Sunex Tools or its
authorized warranty service centers.The foregoing obligation is Sunex
Tools' sole liability under this or any implied warranty and under no
circumstances shall we be liable for any incidental or consequential
damages.
Note: Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or
exclusion may not apply to you. Please contact your local Sunex
distributor for proper warranty handling procedures.
If you have any questions about warranty service, please write to
Sunex Tools. This warranty gives you specific legal rights and you
may also have other rights which vary from state to state. Repair kits
and replacement parts are available for many of Sunex Tools products
regardless of whether or not the product is still covered by a
warranty plan.
Shipping Address: Sunex Tools • 315 Hawkins Rd. • Travelers Rest,
SC 29690
Mailing Address: Sunex Tools • P.O. Box 4215 • Greenville, SC 29608
2
1003
3 Ton Capacity
Jack Stand
1006
6 Ton Capacity
Jack Stand
Note: Replacement parts are
not available due to safety
precautions.
REV. 8/29/06
®
9/6/06 1:49:57 PM