Threaded
Hole
Stud
Sleeve
Escutcheon
1. Install the Faucet
IMPORTANT! If you are mounting the faucet to an uneven surface
(such as tile grout lines), apply a suitable sealant in addition to the
O-rings provided. Do not use petroleum based sealant.
Thread the stud into the threaded hole of the faucet body until
the stud bottoms out.
Insert the O-ring into groove of the escutcheon.
Slide the sleeve and escutcheon around the threaded stud and
supply hoses until it is seated against the base of the faucet body.
Insert the supply hoses and stud through the mounting hole.
NOTE: The handles will rotate toward the user when properly
installed.
Slide the bracket and nut onto the stud from underneath the
mounting surface.
Securely tighten the nut.
Ensure the handles are in the OFF position, as shown.
Kohler Co.
Faucet Body
Supply Hose
O-Ring
Bracket
Nut
3
1069123-2-B