Sears Kenmore 116.31912 Manual Del Propietário página 15

ii: i i ii!i ii i i i ii ii i i i iii i i i i i i i iiiii iiiiiiiiiiii i
iiii:ii:i_i 'iii 'i' i' i' i' i' i' i i ' i' i' i' i' i' i i _ i ' i' i' i' i:i ' i i:i:1%:i:iii_i:i:i:i_ii_C_C_i_i:i:i:i_i_1%%,, ii:_ :,:: _%: 11:1% _::: i_'ii:_ :::i_': _" _i '_'_ _'_: _' ;' i' _' _'_i _ :' _' _" _' :_' i_' :' :' _" ;;'_':_'_'_' :' _' _'_: _' :' _ '_:_:%::::i:i:i:i:i:i:i_i_i_ii
TO REMOVE DUST BAG
WARNING
Pull out on the
bag cover release
located near the
top of the bag
cover.
Bag //_I1
oo- H
Bag
Pull the bag
cover forward
and lift up.
Remove and lay
aside.
Grasp the dust bag ht'_JJ _ J_
collar and pull gently, _"
carefully removing
the dust bag.
Dust
dustThrow away the used bag. _. F'_ as'
Do not reuse.
- B,_l.lold_r Check the bag
holder and the
Cavity motor safety fil-
ter. If either is
blocked, check
- Motor
Safety TROUBLE-
Filter SHOOTING.
_,f,_CAUTION
NEVER REUSE A DUST BAG. Very
fine materials, such as carpet freshen-
er, face powder, fine dust, plaster,
soot, etc. can clog the bag and cause
it to burst before it is full. Change bag
more often when vacuuming these
materials.
TO REPLACE DUST BAG
Unfold the new Dust
dust bag. Fold Bag
the safety seal
tab on the new
dust bag away
t,
from the open- //
ing that fits on
/
the bag holder.
NOTE; See PARTS AND FEATURES for
bag number.
Insert the dust bag
onto the bag holder
completely by hold-
ing the bag collar.
Place the dust bag
collar into position.
Tuck the bag
behind each of the a,,#
four bag retention RetenUon
corner flaps shown corner
here. Be sure the
bottom and sides
of the dust bag are
completely within
bag cavity prior to
replacing the bag
cover.
Seal Tab
Slots
Position the bag
cover so its posi-
tioning tabs fit
into the body
positioning tab
slots.
Close the bag
cover.
You will hear a
distinct snap Bag
when cover is
securely closed.
Check to see that the dust bag is fully
enclosed in the bag cover.
15