GB
Attaching/removing the carrycot:
Put the back rest and the foot rest in lying position and remove the bow.
Now put the carrying bag on the lying area of the seat (fig.24). For a safe fastening
of the carrying bag, put the two safety pins - which are fixed on the carrying bag -
into the notches of the bow on the frame (fig.25). Through pulling slightly on the
safety pins you can see if they are locked in place.
For additional fixing, embrace the two straps of the carrycot to the backrest of the
seat part and fix it tightly with the plastic clip.
To remove the safety pins, press the locking mechanism on the sides (fig.17).
ATTENTION: If you use the baby buggy with the carrying bag, always fasten it with
the safety pins.
Usage your baby stroller with a pram body:
Setup of the stroller case:
Remove the fabric mattress (lie down area) first, to set up the stroller case. Now
push both spring clips outwards, until the clips latch in the indentations and the
stroller case is spanned (fig. 26). Then, you can put the fabric mattress into the
carrier bag again.
For folding the stroller case, remove the fabric mattress (lie down area) first, then
push both spring clips inwards (fig. 27). Afterwards you can put the fabric mattress
back into the carrier bag.
Attachment & detachment of the stroller case:
To put on the stroller case, remove the piece for sitting from the framework, first.
Now put the stroller case onto both receiving openings at the framework until you
can hear a latching sound (fig. 6). For stabilization of the stroller case, swing open
the bow (fig. 28) that is on the bottom side of the stroller case and attach it to the
rear support of the shopping basket (fig. 29).
ATTENTION: The stroller case can only be put up in a manner that the viewing
direction of the child is opposite to the direction of motion- otherwise safe
attachment is not possible.
For detachment of the stroller case, remove the bow, release the stabilization bow of
the stroller case and retract it again. Then push both grey handles (left and right
side) downwards and lift the stroller case from the framework (fig. 30).