Adjust The Harness - Cramer 82B1300 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
To Remove the Dust Cover
EN
1
Unlock the latches on both sides to release the dust cover.
2
Remove the dust cover to expose the battery compartment.
NOTE: Please keep the battery cap installed to prevent entry of dust or water.
To Remove
(see Figure 6)
1
Press and hold the battery release button (M) with firm grip.
2
Grasp the backpack firmly. Pull the battery pack out of the compartment.
NOTE: The blower can hold two batteries, but only one of the batteries works
during operation.
To Install
(see Figure 6)
1
Align the battery pack with the cavity in the backpack housing.
2
Insert the battery pack into the backpack housing.
3
Grasp the backpack firmly.
4
Push the battery pack into the backpack until it locks into place.
You will hear a click once it is locked into place.
5
Do not use force when inserting the battery pack. It should slide
into place and click.
To Put on the Backpack

Adjust the Harness

A well adjusted backpack blower and harness makes work easier. Adjust the
harness to give you the best working stance. Adjust the side straps so the weight
is equally distributed across your shoulders.
a
Once the blower is properly fitted on your back, pull the ends of the straps
downward to tighten the harness.
8
cramer.eu
(see Figure 7)
b
Connect the horizontal chest strap, and pull the end of the strap to tighten.
c
Lift the tabs of the adjusters to loosen the straps.
d
Close and lock the quick-release fastener by pushing it together.
e
Squeeze the hooks to open the quick-release fastener.
Harness Removal
WARNING!
The backpack blower must be quickly removed in the event of
imminent danger. The chest and waist strap must be released
before putting the backpack blower on the ground.
1
Open the quick-release fasteners on both chest strap and waist strap.
2
Loosen the harness straps by lifting the sliding adjusters and then take off
the blower.
Put on the Shoulder Strap.
1
Adjust the harness straps (1) to the correct length.
2
Adjust chest strap (2) and waist strap (3) to correct length and fasten it
together.
Operation
WARNING!
Do not allow familiarity with this product to make you careless.
Remember that a careless fraction of a second is sufficient to
inflict serious injury.
(see Figure 7)

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

2400186

Tabla de contenido