Carton Contents; Intended Uses - sunjoe PPG400 Manual Del Operador

Unpacking

Carton Contents

• Portable power station
• AC charger
• Manual with registration card
1. Carefully remove the power station and check to see that
all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe + Sun Joe
®
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use your new power station.
The packaging is made of recyclable materials. Properly
dispose of these materials in accordance with local
regulations.
IMPORTANT! The equipment and packaging material are not
toys. Do not let children play with plastic bags, foils or small
parts. These items can be swallowed and pose a suffocation
risk!
Operation
m
WARNING!
Do not allow familiarity with this product
to make you careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
m
WARNING!
Do not use any attachments or accessories
not recommended by the manufacturer of this product. The
use of attachments or accessories not recommended can
result in serious personal injury.
m
WARNING!
Do not modify or attempt to repair the
power station except indicated in the instructions for use and
care.
m
WARNING!
The device shall be stored indoors. The unit
shall not be charged outdoors. When in use, cautions should
be taken to reduce the exposure to rain, sleet, and snow.

Intended Uses

This power station is used for supplying electrical power for
operating compatible small electronics and USB-powered
devices. The continuous output wattage of this product is
limited to 384 W total when supplying backup power. This limit
applies to the total of all items plugged into the power station.
customer service center at
®
LCD Screen (Fig. 1)
Fig. 1
Battery charge
level indicator
AC output
status
1. Battery charge level indicator – This icon indicates the
remaining power in the battery. Refer to the table below
for the meaning for each symbol.
20% 40%
NOTE: The power station must be recharged when the
power drops to 20% or less.
2. Output power indicator – indicates the actual output
power when there are devices connected and running/
being charged by the power station.
NOTE: When the total output is less than 5 W, the power
station may not be able to detect the output power due
to the small power output. The output power indicator
will show 0 W. This will not affect the actual output to the
connected device.
3. AC output status – After turning on the power station,
the AC icon will light up when the AC output switch is
pressed.
4. USB output status – After turning on the power station,
the USB icon will light up when the DC output switch is
pressed.
5. LED light indicator – After turning on the power station,
the LAMP icon will light up when the LED light is turned
on.
6. Overheat warning – The warning icon will light up if the
power station overheats during operation, at which point
it will stop working.
4
Output power indicator
USB output
Overheat LED light
status
warning indicator
60% 80% 100%