Glacier bay 67569W-6001 Guía De Uso Y Mantenimiento página 5

Installation (continued)
4
Preparing the pop-up assembly
□
Remove the stopper (F) and ange (G).
□
Screw the nut (I) all the way down, and push
the gasket (H) down.
H
I
F
G
5
Installing the pop-up body and
pop-up flange
□
Apply silicone to the underside of the ange (G).
□
Insert the pop-up body (J) into the sink. Screw
the ange (G) onto the pop-up body (J). The
pivot hole (1) must face the back of the sink.
□
Use the groove joint pliers to tighten the nut (I),
but do not over tighten. Do not turn the pop-up
body (J) while tightening the nut (I) or the
sealant may not seal properly. Clean away any
excess putty.
□
Open the easy install rotating clip (K).
I
5
Please contact 1-855-HD-GLACIER for further assistance.
G
J
1
Open
K
HOMEDEPOT.COM