Troubleshooting - Glacier bay VWD1066BLS Guía De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting

Problem
The water dispenser
is leaking.
The water is not hot or
cold enough.
The water dispenser is not
dispensing water.
The water dispenser is
noisy.
nOTe: Do not return this product to the store. For questions on operation, assembly, or parts, please contact us at www.homdepot.com or
1-877-527-0313.
Possible cause
The drain cap and silicone seal are not secure.
All the water in the tank has been used.
The unit is un-plugged.
The kettle feature was not activated.
The circuit breaker in your home is tripped or the fuse
has blown.
The temperature limit has been reached.
The thermostat needs to be adjusted to a cooler level.
The water bottle is empty.
Mineral deposits are clogging the tanks.
There is a possible air pocket.
There is possible ice buildup because the thermostat is
set too cold.
The bottle is making a gurgling noise as it fills the
tank.
The water dispenser is not level.
Suggested Solution
Ensure the seal is secure in the drain plug, and
tighten the drain cap.
Replace the empty bottle with a full one, and wait
approximately 1 hour for the water to cool / 3
minutes for the water to heat (after activating the
kettle feature button).
Plug the unit into the outlet.
Activate the kettle feature by pressing the kettle
feature button.
Reset the breaker or replace the fuse.
Allow the temperature of the hot water tank to cool
for approximately 30 minutes. The temperature
limit thermostat will re-set automatically once
sufficiently cooled, and the cooling system will
reactivate automatically. To operate the hot water
system, press the kettle feature button.
Adjust the thermostat between MIN (cool) and MAX
(colder) levels to achieve the desired temperature.
Replace the empty bottle with a full one.
See "Cleaning the Reservoirs".
Push down on the dispenser buttons to prime the
unit.
Unplug the unit overnight, then reset. Set the ther-
mostat to MIN, slowly increasing based on your use
and need for cold water.
This is normal.
Make sure the dispenser is on an even surface that
can support its full weight.
11
Please contact 1-877-527-0313 for further assistance.
HOMEDEPOT.COM

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

236-824

Tabla de contenido