Hayward SharkVAC XL Manual Del Propietário página 8

8. Remove the cleaner from the water at the shallow end of the pool by gently pulling the cable until
the cleaner reaches the surface. Then lift it out of the water using the handle, NOT the cable.
9. If the supply cord is damaged it must be replaced by the manufacturer, service agent, or similarly
qualified persons in order to avoid a hazard.
10. All electrical connections must be done by a qualified electrician according to local electrical
standard (see p16).
Operating the cleaner using an aftermarket timer
If you are using an aftermarket timer to turn your cleaner on please follow these instructions:
1. Plug the aftermarket timer into the nearest GFCI (Ground Fault Circuit Interrupter) protected 110-
120 volt AC outlet and then plug the power supply into the timer.
2. The cleaner operates on a 3 hour cycle so set the timer duration for 3 hours or more. If you set the
timer duration for less than 3 hours the cleaner will only operate for the period of time you set. If
you set the timer duration for longer than 3 hours the cleaner will stop automatically at the end of
its 3 hour cycle. Should a second cleaning cycle be required, switch OFF the power supply for 10
seconds and restart.
CAUTION: When removing cleaner from the pool do NOT reel it around your arm. The cleaner is heavy
and may cause someone to lose their balance and fall into the pool. To avoid falling into the pool, gently
reel the cable in hand-over-hand from the shallow end of the pool.
DO NOT ENTER THE SWIMMING POOL WHEN THE CLEANER IS OPERATING.
Optimum operating water temperature range for the cleaner is 50ºF - 100ºF (10ºC - 35ºC).
Remove the cleaner from the pool, empty the filter bucket and clean filters after each use. Keeping the
cleaner permanently in the pool may result in additional service requirements. (see maintenance section for
cleaning instructions)
Store the cleaner in a shaded area.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
8