Denver MLC-3201MK2 Manual Del Usuario página 4

Section 2: Stand Installation
Keep the foam over the monitor before attaching the stand. Follow the
steps below to finish the installation.
1. Open the package, take out the product with foam still attached, and gently
place it on a desktop or table.
2. Take out the two parts of the stand, remove the foam covering the back of the
monitor, and
press
the
button
to
remove
the
stand
plate.
3. Use the screwdriver and two 12mm NO.1 screws to fasten the stand plate to
the
stem.
Next,
use
the
remaining
14mm
stand
screws
to
fasten
the
base





to
the
stem.
NO.1 Screws
12mm
x
2
Stand Stem
4. Insert the stand's plate into the opening on the back of the monitor. It should
click into place. Make sure the stand is securely attached to the back of the
monitor then remove the monitor from the remaining foam section and stand
it up on a table or desk as desired.
If needed, the stand can easily be detached from the monitor by pressing the
button near the stand plate. Make sure the monitor is laid on a flat surface
before removing the stem.
Monitor
Stem
Stand
Plate
Eng-4
Monitor
Stand
Base
Stand Stem
Foam
Stand
Plate
Button
NO.1
Screw
14mm
x
1
Button