Getting Started; Main Unit; Outdoor Thermo Sensor; Installation - Ea2 BL506 Manual Del Usuario

3. Outdoor Thermo Sensor

D1: Transmission Indication LED
D2: Wall Mount Hole
D3: Channel Select Switch

4. Getting Started

4.1 Main Unit:

• Open main unit battery compartment cover [C1]
• Insert 2 x AAA batteries observing polarity [" +" and " –" marks]
• Replace main unit battery compartment cover [C1]
• Use a pin to press the RESET [B4] button on the rear of the main unit, the main unit is
now ready for use
4.2 Outdoor Thermo Sensor
• Batteries compartment (D5) of thermo sensor is locating behind the back cover,
unscrews the batteries cover to open.
• Insert 2 x AAA batteries observing polarity [ "+" and "–" marks]

5. Installation

5.1 Main Unit
Place the main unit onto flat surface (C3).
5.2 Outdoor Thermo sensor
The remote sensor should be securely mounted onto a horizontal surface.
Note:Transmissions between receiver and transmitter can reach up to 30m in open area.
Open Area: there are no interfering obstacles such as buildings, trees, vehicles, high
voltage lines, etc.
ENGLISH 4
D4: "TX" button
D5: Battery Compartment
D6: Stand

6. Thermometer

6.1 RF Transmission Procedure:

• The main unit automatically starts receiving transmission from outdoor thermo sensor
for outdoor temperature after batteries are inserted.
• The thermo sensor unit will automatically transmit temperature signal to the main unit
after batteries inserted.
• For having more than one external transmitter (Maximum3), select the Channel, CH1,
CH2 or CH3 to ensure each sensor is transmitting difference channel before inserting
batteries. The channel select switch (D3) is at the back of the thermo sensor.
• Press "TX "button (D4) on the thermo sensor unit to transmit temperatures signal to
the weather station manually. The weather station gives a "beep" sound if it received
the temperature.
Note: Buttons (except "Light" button (B1)) will not function while scanning for thermo
sensor's signal unless they are well received or stopped manually.

6.2 Temperature:

(1) Temperature--- Channel Selection
• Press "CHANNEL" button (B8) and select to view the Indoor temperature and 3
Outdoor Channel's temperature. The sequence is shown as follow:
PRESS "CHANNEL" button and select to view
• When viewing outdoor temperature, hold "CHANNEL" button (B8) for 3 seconds to
remove a channel manually. It will automatically register a new channel again if a new
channel is received. If there is no temperature displayed in existing channel ("- - . –"is
displayed on the LCD), hold "CHANNEL" button (B8) for 3 seconds to cancel that
channel and receive the channel again.
(2) Temperature Trend
• The trend pointer (A5) displayed on the LCD indicates the trend of the temperature for
current channel (Indoor, Outdoor CH1, CH2 and CH3).
Indicating the temp. is rising
Indicating the temp. is steady
ENGLISH 5
Display the indoor & three
channels alternatively
Indicating the temp. is falling