allen+roth 75-102 Manual De Instrucciones página 4

INSTALLATION INSTRUCTIONS (Continued)
4. Tighten mounting screws (AA) into the drywall anchors (BB),
leaving 3/8 in. space between the screw head and the wall.
Hardware Used
BB
Drywall anchor
AA
Mounting screw
5. Connect the white wire from the mirror (A) to the white wire from
the electrical box. Connect the black wire from the mirror (A) to the
black wire from the electrical box. Connect the green ground wire
from the mirror (A) to the ground wire from the electrical box. Cover
and secure each wire connection with a wire connector (CC).
Mirror
white
green
black
Hardware Used
CC
Wire connector
6. Insert the screw heads into the keyholes on the mirror's mounting
bracket, then carefully let the mirror (A) drop down so the screw
heads slide into the narrow ends of the keyholes, securing the
mirror (A) in place.
Once the mirror (A) is securely in place, turn on the power at the
circuit breaker or reinsert the fuse.
OPERATING INSTRUCTIONS
Turn on wall switch to turn light and defogger pad on.
NOTE: The defogger pad will only work when light is on. The defogger pad and light cannot
be wired separately.
1. Touch the sensor button to turn ON the light.
2. Touch and hold the sensor button to dim the light. Release the button when the light
reaches the desired brightness setting.
3. When the LED gets to the maximum or minimum brightness setting, it will stop. Release,
then press and hold the button to go in the opposite direction, where it will stop at the
maximum or minimum brightness setting.
4. Touch the sensor button to turn OFF the light.
NOTE: The mirror is equipped with a memory feature to preserve the previous brightness
setting, when turning the light back on.
House
Electrical
Wires*
neutral white
green
ground
live
black
x 4
x 4
*House wires may vary
in color. Please be sure
to verify actual house
wires with a certified
electrician before
installation.
x 3
4
4
5
6
BB
AA
A
A