Handy
4.3 Connect the power plug to the
EN
power outlet
When the power plug of the battery charger is
connected to the AC power outlet, the indication
DE
light will light up.
Charging
FR
Charge complete
The main body may become warm during charg-
ES
ing. This is not an abnormal sign.
4.4 Charging time
PT
NiMH model
IT
Li-lon models
5. Waste disposal
NL
• Try to dispose the vacuumed waste as fre-
quently as possible. The dust attached to the
SV
fi lter can cause poor vacuuming performance
and stress the motor.
• Always switch OFF the power when operating
NO
for disposal.
1. Detach the dust container.
DA
2. Pull out the fi lters.
3. Empty the dust container.
4. Re-install the fi lters in correct order and posi-
FI
tion.
5. Re-install the dust container to the vacuum
unit.
Caution
EL
Do not vacuum a lot of dust at anyone time and
do not vacuum large objects. May cause the suc-
tion port to clog and loose the suction power.
TR
Do not vacuum kerosene, petrol or butts of
smoked cigarettes. This may cause a fi re.
CS
Dispose dust frequently in order not to damage
the product.
SL
6. Service and
Maintenance
HU
Always switch OFF the power and disconnect the
power plug for the battery charger from the power
RO
outlet before starting maintenance
6.1 Vacuum Unit, Charging Base
BG
Wipe off any dirt from the product using a dry and
soft rag.
PL
In case of stubborn dirt, clean using a soft damp
6
Red light on
Blue light on
Hours
16
4
rag soaked in a water solution diluted with a little
neutral detergent and then wipe with a dry rag.
Do not use solvents like thinner, benzene, and
spray type cleaners.
6.2 Dust Container
Remove any collected dust inside the dust con-
tainer fi rst and wash using lukewarm water.
Make sure that the dust container is completely
dry before re-assembling.
6.3 Filter
Do not wash the fi lters in the washing machine.
Do not dry them using a hot air blower such as a
dryer or a hair dryer.
In case of stubborn dirt or loss in suction power,
wash as instructed below:
1. Remove the dust fi rst
2. Wash with water
3. Make sure that the fi lters are completely dry
before the parts are re-assembled.
7. Product Disposal
When the battery pack will no longer hold a
charge, the product has reached the end of its
useful life.
The battery pack is not replaceable. After remov-
ing the battery pack, the product must be dis-
carded.
Before discarding the product, the rechargeable
battery pack must be removed and recycled in
accordance with federal and local laws, as out-
lined below.
WARNING: The vacuum cleaner must be discon-
nected from the charging station and batteries
must be run fl at before removing the battery pack.
1. Use a screwdriver to unscrew the housing.
2. Cut the wires in order to free the battery
compartment from the unit. Cover visible metal
areas with tape..
3. Take out the battery compartment with motor.
Unscrew the battery bracket. Remove the bat-
tery from the unit. WARNING: Do not mutilate
or incinerate the battery pack, as it will explode
at high temperatures.
WARNING-- Risk of fi re or serious injury:
Never touch both terminals of a battery pack with
metal objects and/or body parts as a short circuit