MAX TOOLS AR300 Manual Del Usuario página 10

English
Installation of the hose reel
In case of ceiling mounting: install the hose reel at a height of not less
than 3 meters.
To mount the hose reel you need the appropriate equipment.
1. The hose reel is provided with 3 holes of 10.5 mm for assembling
on a smooth surface.
2. Figure 1 shows the correct positioning of the holes necessary for
assembling.
3. Use the 3 holes in the support base to mount the hose reel in the
desired position. Be sure that the fastening systems are suitable for
the purpose.
4. Apply either teflon tape or some adequate sealant for fittings and
then connect the air/water supply. The other end of the hose can be
connected with the desired equipment. At this point, check for any
air/water leakages.
5. To regulate the STOPPER (fig. 2) at the desired length, extract the
hose and block it in the desired position. Loosen the screws of the
STOPPER, place it in the required position and then tighten the
screws again.
Fig. 1
10