1. Set the 'wash selector' to 'wash-rinse'.
2. Put the clothes to be washed into the wash tub. Select the water level according to the weight and material
of clothes.
3. Put suitable amount of detergent into the wash tub.
4. Select the washing time according to fabric type and dirtiness of clothes (see ITEM.3) Turn the wash timer
knob and press the 'Cycle selector'.
5. Wash the washing is finished, remove clothes from the wash tube and select 'DRAIN' from the wash selector.
1. WASH:
2 .WASH SUGGESTION
1. When washing heavily soiled cotton or linen fabric, wash them first in clean water away. Then wash them in
water with detergent so as to reduce the consumption of detergent and improve the wash effect.
2. Add a small amount of detergent on shirt cuffs, collars and other heavily soiled area. Rub them by hands or
brush.
3. Use liquid soap or high class detergent with less foam.
4. Use warm water may improve the washing effect.
3. WASH MODE AND WASH TIMER
Fabric Type
Level of solid mode
Wash Timer (Min)
Rinse Timer (Min)
TROUBLES AND REPAIRS
* Pulsator ceased running
Power failure or plug dropped off
Insert plug well
V-Belt dropped off
Put on V-Belt properly.
Pulley loosened
Tighten pulley screw.
Foreign matter jammed pulsator
Remove foreign matter
* Abnormal noise and vibration
Fraction between pulsator and wash tub
Adjust the gap between them
Foreign matter jammed pulsator
Remove the foreign matter
Over tighten V-Belt
Adjust properly
* Pulsator runs at low speed
Slacken V-Belt
Adjust properly or replace with a new screw
Motor fixing screws loosened Tighten V-Belt and screw
WASHING PROCEDURE
Silk, Wool
Cotton, Linen
Light
Light
2-5
5-10
2-3
3-5
- 7 -
Cotton & Hemp
Light
10-15
5-8