Recalling Equalizer Curves; Adjusting 3-Band Parametric Equalizer - Pioneer DEQ-P7650 Operación Manual

Digital Signal Processor

Recalling equalizer curves

There are seven stored equalizer curves which
you can easily recall at any time. Here is a list
of the equalizer curves:
Display Equalizer curve
POWERFUL Powerful
NATURAL Natural
VOCAL Vocal
EQ FLAT Flat
CUSTOM1 Custom 1
CUSTOM2 Custom 2
SPR-BASS Super bass
! CUSTOM1 and CUSTOM2 are adjusted
equalizer curves.
! When EQ FLAT is selected no supplement
or correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
EQ FLAT and a set equalizer curve.
% Press EQ to select the equalizer.
Press EQ repeatedly to switch between the fol-
lowing equalizers:
POWERFULNATURALVOCALEQ FLAT
CUSTOM1CUSTOM2SPR-BASS
Adjusting 3-band parametric
equalizer
For CUSTOM1 and CUSTOM2 equalizer
curves, you can adjust the front, rear and cen-
ter equalizer curves separately by selecting a
center frequency, an equalizer level and a Q
factor for each band.
! A separate CUSTOM1 curve can be cre-
ated for each source.
! A CUSTOM2 curve can be created com-
mon to all sources.
! The center speaker largely determines the
sound image and getting the balance right
isnt easy. We recommend reproducing a 2-
ch. audio (a CD for example) and getting
the balance right among the speakers ex-
cept for the center, and then reproducing a
5.1-ch. audio (Dolby Digital or DTS) and ad-
justing the center speaker output to the
balance you have already got among the
other speakers.
1 Press AUDIO and hold until FRONT ap-
pears in the display, then press AUDIO to
select PEQ.
After FRONT is displayed, press AUDIO until
PEQ appears in the display.
2 Press a or b to select the desired item.
Each press of a or b selects the speaker in
the following order:
FRT (front speakers)CEN (center speaker)
RER (rear speakers)
# You cannot select speakers whose size is set
at OFF.
3 Press d and then press a or b to select
the equalizer band to be adjusted.
Each press of a or b selects equalizer bands
in the following order:
LOW (low)MID (mid)HIGH (high)
4 Press d and then press a or b to select
the center frequency of selected band.
Each press of a or b selects the frequency in
the following order:
40Hz50Hz63Hz80Hz100Hz125Hz
160Hz200Hz250Hz315Hz400Hz
500Hz630Hz800Hz1kHz1.2kHz
1.6kHz2kHz2.5kHz3.1kHz4kHz
5kHz6.3kHz8kHz10kHz12kHz
5 Press d and then press a or b to adjust
the equalizer level.
Each press of a or b increases or decreases
the equalizer level. +6  6 is displayed as the
level is increased or decreased.
Section
03
17
En