Understanding Auto Ta And Eq Error Messages - Pioneer DEQ-P7650 Operación Manual

Additional Information
Symptom
No sounds are heard.
DVD player setting
Symptom
No sounds come from the DVD
player only.

Understanding auto TA and EQ error messages

When correct measurement of car interior acoustic characteristics is not possible using the auto
TA and EQ, an error message may appear on the display. If an error message appears, refer to the
table below to see what the problem is and the suggested method of correcting the problem. After
checking, try again.
Message
ERR MIC
ERR FSP, ERR FLSP, ERR FRSP,
ERR CSP, ERR RLSP, ERR RRSP,
ERR SW
ERR NOIS
Cause
Optical cables are incorrectly con-
nected.
Cause
Optical cables are incorrectly con-
nected.
The DVD player is not properly set
for output.
Cause
Microphone is not connected.
The microphone cannot pick up the
measuring tone of a speaker.
The surrounding noise level is too
high.
Action
Connect the cables correctly. (Page 3)
Action
Connect the cables correctly.
Make the correct output setting. (See the
manual for the DVD player.)
Action
Plug the supplied microphone securely into
the jack.
! Confirm that the speakers are connected
correctly.
! Correct the input level setting of the power
amp connected to the speakers.
! Set the microphone correctly.
! Stop your car in a place that is as quiet as
possible, and switch off the engine, air condi-
tioner or heater.
! Set the microphone correctly.
Appendix
21
En