Charging Procedure; Battery Charger - Verdemax V004352 Manual De Usario

WARNING
lf the battery pack cracks or breaks, with or
without leaks, do not recharge it and do not
use. Dispose of it and replace with a new battery
pack. DO NOT ATTEMPT TO REPAlR lT!
To avoid injury and risk of fire, expolsion,
or electric shock, and to avoid damage to
the environment:
· Cover the battery's terminals with heavy-
duty adhesive tape.
· DO NOT attempt to remove or destroy any
of the battery pack components.
· DO NOT attempt to open the battery pack.
WARNING
· lf a leak develops, the released electro-
lytes are corrosive and toxic. DO NOT get
the solution in the eyes or on skin, and do
not swallow it.
· DO NOT place these batteries in your
regular household trash.
· DO NOT incinerate.
· DO NOT place them where they will
become part of any waste landfill or
municipal solid waste stream.
· Take them to a certified recycling or
disposal centre.

BATTERY CHARGER

SPECIFICATIONS
20V quick battery charger (cod. V004351)
Input: 220-230V AC 50-60Hz
Output: 20V 2A
CHARGING PROCEDURE (CGA202)
NOTE: The battery is not shipped fully charged.
It is recommended to fully charge before use to
ensure that maximum run time can be achieved.
This lithium-ion battery will not develop a
memory and may be charged at any time.
1. Plug the charger into an AC power outlet.
2. lnsert the battery pack (1) into the charger
(2).
EN
SPECIFICATION
20 V 2A Dual charger (V004355)
Input: 220-230 V AC 50-60 Hz
Output: 20V 2A

CHARGING PROCEDURE

NOTE: the battery is not shipped fully charged.
It is recommended to fully charge before use to
ensure that maximum run time can be achieved.
This lithium-ion battery will not develop a
memory and may be charged at any time.
1. Plug the charger into AC power outlet
2. Insert the battery pack (1) into che charger
(2).
This is a diagnostic charger. The Charger LED
Lights (3) will illuminate in specific order to
communicate the current battery status. They are
as follows:
CHARGING PROCEDURE (LED INDICATOR)
BATTERY IS CHARGING:
FULLY CHARGED:
BATTERY IS TOO WARM:
(REMOVE FOR APPROX. 30
MINUTES TO ALLOW TO COOL)
NO BATTERY PRESENT:
CHECKING THE CHARGER
lf the battery pack does not charge properly:
• Check the current at the power outlet with
another tool. Make sure that the outlet is not
turned off.
• Check that the charger contacts have not been
shorted by debris or foreign material.
lf the surrounding air temperature is not
normal room temperature, move the charger
and battery pack to a location where the
temperature is between 7°C and 40°C.
This product requires assembly.
lf the battery is inserted into the charger when
warm or hot, the CHARGlNG LED indicator
light on the charger may switch on and
illuminate ORANGE. lf this occurs allow the
battery to cool outside of the charger from
approximately 30 minutes.
7
RED
GREEN
GREEN
GREEN
WARNING
Original instruction