Linea 2000 DOMO DO1093HD Manual De Instrucciones página 20

I CLEANING AND MAINTENANCE
· To protect against electrical shock or burns, do not immerse unit, cord, or plug in water or other liquid.
· Failure to maintain this appliance in a clean condition could adversely affect the life of the appliance
and possibly result in a hazardous situation.
I PRODUCT-SPECIFIC WARNINGS
· Make sure that the cord is not damaged, twisted, bent, or crushed. Do not pull on the cord or place
anything on top of it.
· Never block the air inlet or air outlet.
· Do not use or store the hairdryer in a humid environment such as near a bath, shower, in a bathroom,
etc.
· Nevertheless, if the appliance should fall into water, immediately unplug it from the mains supply.
Never put your hands in the water.
· The air outlet and attachments could become hot during use. Do not touch them.
· Make sure that the plug is fully plugged in before switching on the appliance.
· Do not drop the appliance. This may result in electric shock or fire due to short circuit.
· Do not use the hairdryer if the air intake is damaged.
· Stop using it if you see fire in the air outlet. Clean the appliance thoroughly and remove dust from the
inlet or outlet.
· Always keep 10 cm between your hair and the air inlet. Always keep 3 cm between your hair and the air
outlet.
· The hairdryer is protected from overheating. The power supply is cut off if the appliance overheats.
Switch off the appliance and allow it to cool down for a few minutes. Clean the appliance thoroughly
and remove dust from the inlet or outlet before switching it on again.
· The appliance could become hot during use. Persons who cannot perceive heat should not use the
appliance or should only use it under supervision.
· Wait for the appliance to cool down before storing it.
· To avoid electric shock, do not insert any metal objects through the air vents.
· Do not use the appliance on artificial hair.
· For extra safety, we advise you to install a residual current device (RCD) in the electrical group
supplying the bathroom. This residual current-operated circuit breaker must have a value that does
not exceed 30 mA. Consult the installer.
· Clean the air inlet regularly to avoid dust accumulation. Pull the plug out of the socket and clean with
a dry cloth.
It is not permitted to use the appliance in the shower or bath.
20
DO1093HD
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE