Everbilt 1005129161 Guía De Uso Y Cuidado página 21

Installation (continued)
D. Adjustment of push button function: Turn on the water supply, and after the water tank is filled with
water, install the water tank lid. Lightly press the full and half push buttons (F≈3N). (Note: Lightly press
full or half push buttons so that flush valve will not be activated for flushing). Measure the distance L4
that button is pressed down, and confirm that the value of L4 is between 2mm and 4mm. (If L4> 4mm,
the push rod is too short; L4 <2mm, the push rod is too long. Then, readjust the length of the
push rod according to step 9D); At this time, test the functions of the push button. Press the full flush
button to perform full flush, press the half flush button to perform half flush, and the function should turn
out OK.
E. The toilet can be used normally after the above steps are adjusted properly.
After the parts are installed, they must not interfere with each other to avoid affecting their functions.
4
~ ~
F 3N
2x magnification
11
HOMEDEPOT.COM
Please contact 1-800-305-1726 for further assistance.