Everbilt 1005129161 Guía De Uso Y Cuidado página 23

Maintenance
Replacement of seal
1) Turn off water supply and flush the toilet.
2) Remove the lid from the toilet tank - do NOT remove the button from the lid.
3) Note position of the half and full flush paddles on the top of the flush valve (Figure 1).
4) Holding the valve body, rotate the valve until it is possible to remove the valve body from the shank
(Figure 2).
5) Holding the edge of the silicone seal, pull the seal and peel away from the sealing piston - discard
the old seal.
6) Place the inside edge of the replacement seal against the inside edge of the sealing piston (Figure
3).
Important Note: Make sure that the thin side (the side with the lettering) faces the outside, and the
rough side (the side without the lettering) faces the inside.
7) Holding the edge of the replacement seal, pull until the seal installs onto the piston.
8) Inspect the seal to make sure the entire inner edge of the seal is making contact with the inner
edge of the sealing piston.
9) Replace the valve body in the shank, and rotate the valve until the position of the half and full flush
paddles are returned to their original position (Figure 4). Rep lace the lid and turn on the water supply.
1
Half flush
Full flush
push button
push button
2
SEAL LOCATION
3
The thin side that with
the letter faces outward
Thin side
12
4
Thin side