9. Re-check all connections. Install the lanyard assembly with the fork seated over the plunger.
10. Replace engine cover.
11. Reconnect battery.
12. Start engine.
If engine does not start
Disconnect battery,
Remove engine cover,
Re-check all electrical connections,
Replace engine cover,
Reconnect battery, and
Re-start engine.
13. Remove lanyard assembly. Engine should stop immediately.
CAUTION: If engine fails to stop re-check all wiring. Should the engine fail to start or stop, or resumes running with the lanyard fork removed, consult your local
marine dealer for assistance.
INSTALLATION NOTES
ALL WIRING, CONNECTIONS AND TERMINATIONS should be done in accordance with ABYC Spec. E-3-73 and E-9-81.
Recommended 1/4 female terminals: Sierra P/N EC04150 or equivalent.
Use 14 AWG Purple standard, insulated marine quality wire for I/O or inboard applications. (Type HDT, THW, UL 1426 or equivalent)
Use 14 AWG Black standard, insulated marine quality wire for all outboard applications. (Type HDT, THW, UL 1426 equivalent)
OPERATING INSTRUCTIONS
1. Before each motor start, check that the lanyard fork is properly seated over the switch and rotates freely, and inspect the lanyard. If it is cut, worn or frayed it
must be replaced.
2. Attach the lanyard snap hook securely to the operator's body. Do not attach the hook to a belt loop or button hole as these lack the strength to assure proper
switch operation.
3. Start engine.
4. Test the switch by pulling the lanyard fork free from the switch.
CAUTION: If engine fails to stop, re-check all wiring. Should the engine fail to start or stop, or resumes running with the lanyard fork removed, consult your local
marine dealer for assistance.
Do not use another manufacturer's lanyard on SIERRA INTERNATIONAL switch, or change the length of the lanyard as this may affect switch
operation.
MISUSE, MISAPPLICATION, UNAUTHORIZED MODIFICATION, OR INCORRECT INSTALLATION OF THIS SAFETY DEVICE COULD RESULT IN SERIOUS BODILY INJURY
OR DEATH.