Compliance Statements - MIRKA BCA 108 Manual De Instrucciones

en | us • ca
Declaration of conformity
Mirka Ltd, 66850 Jeppo, Finland
declare under our sole responsibility that the product Mirka® BCA 108 Battery Charger is in conformity with the
following standards or other normative documents: Charger safety specification according to EN 60335-1:2012/
A13:2017, EN 60335-2-29:2004/A2:2010, EN 62233:2008, EN 50581:2012, EN 55014-1:2017, EN 55014-2:2015,
EN 61000-3-2:2014, EN 61000-3-3:2013 in accordance with the regulations 2014/35/EU, 2014/30/EU, 2011/65/EU,
2015/863 and 2012/19/EU
Jeppo 25.04.2019
Place and date of issue
Operating instructions include: Safety
rules for battery pack and charger, Additional
information on battery and charger,
Technical data, Battery and charger, Charging
procedure, Charger diagnostics, Disposal
information
Original instructions We reserve the right to make changes to this manual without prior notice

Compliance statements

This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential
installation This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications However, there is no
guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
NOTE: The user is cautioned that any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada's licence-exempt RSS(s) Operation is subject to the following two conditions:
1 This device may not cause interference
2 This device must accept any interference, including interference that may cause undesired operation of the device
Safety rules for battery pack and charger
WARNING!
• Important safety and operating instructions for your battery and charger Before using the charger, read all
instructions and warnings on the charger, the battery pack and the tool
• If the battery pack casing is cracked or damaged, do not insert into charger There is a danger of electric shock or
electrocution
• Do not allow any liquid to get inside charger Electric shock may result
• This charger is not intended for any uses other than charging rechargeable batteries
94
Mirka® BCA 108 • Battery charger
Company
Manufacturer / Supplier
Mirka Ltd
66850 Jeppo, Finland
Tel +358 20 760 2111
Fax +358 20 760 2290
www mirka com
Stefan Sjöberg, CEO